Comparison of disc and drum type brakes drum brake , Mechanical Engineering

Comparison of Disc and Drum type Brakes Drum Brake

Disc Brake

Drum brakes have cooling problem because the friction occurs at internal surfaces, difficult to remove.

Non-uniform wear of brake pads because of curved shape.

Loss of efficiency of braking due to expansion.

Higher weights.

Comparatively low anti-fade characteristics.

Comparatively complex design.

Total friction area is comparatively very high almost four times than disc brake.

Friction surface is in direct contact of air, hence easy cooling.

Uniform wear of pads because of straight shape.

There is no loss of efficiency.

Lower weights.

Comparatively high anti-fade characteristics.

Simple designs.

Low total friction area.

Posted Date: 4/23/2013 3:03:29 AM | Location : United States







Related Discussions:- Comparison of disc and drum type brakes drum brake , Assignment Help, Ask Question on Comparison of disc and drum type brakes drum brake , Get Answer, Expert's Help, Comparison of disc and drum type brakes drum brake Discussions

Write discussion on Comparison of disc and drum type brakes drum brake
Your posts are moderated
Related Questions
Derive mathmatical equation for Bernoull's equation, what are the application of Bernoull's equation and illustrate any one.

New Rule with Local One Step Ahead Prediction: WLS Rule Along with an observation to improve the performance measure of the system, a dynamic posteriori rule, the WLS that is

GAS METAL ARC WELDING (GMAW) GMAW is abbreviation for Gas shielded Metal Arc Welding. Here fusion is achieved by an electric arc formed between work piece and process is called

Write brief notes on the following : (a) Draught System (b) Binary Vapour Cycle (c) Cooling Towers (d) Governing of steam turbines

Q. Method of construction - Plant layout? Plant layout is influenced by the intended method of construction, whether the plant is being constructed on-site, or whether modules

The end plate of a tube is made from 4mm thick steel plate as seen in the figure below. If a 30mm diameter rod welded to the plate is subjected to a force of 10kN, what would be th

The Mechanical Engineer/Specialist shall be responsible for coordinating project issues related to stress analysis, as they relate to his/her equipment, with the Stress Engineer/Sp

i am working as a packaging line design engineer & i need to connect 2 cup filling machines to a single line. how do i solve this

Q. Corrosion Assessment of Flare and VRU System? The worst case scenario shall be considered during material selection of Flare KO Drums. Depending on the fluid composition ent

Match plate pattern These are extensions of the previous type. Here the cope and drag patterns along with the gating and the risering are mounted on a single matching metal or