communication, Mechanical Engineering

is effective commucation an intergral aspect in the mechenical engineering field?
Posted Date: 8/8/2012 10:07:16 AM | Location : United States







Related Discussions:- communication, Assignment Help, Ask Question on communication, Get Answer, Expert's Help, communication Discussions

Write discussion on communication
Your posts are moderated
Related Questions
Determine the maximum hoop: A conical water tank of height 2 metres & base radius 500 mm is supported at top and is full of water. The thickness of the wall is refer to 24 mm,

Jewels can only be removed for polishing from either end of the necklace

The Brasses 70/30 brass also called as cartridge brass contains 70% copper and 30% Zinc. This is employed for cartridge cases, sheet fabrication, and condenser tubes and for u

Question: The disk 3 shown in the figure rotates at a constant angular velocity ω 3 = 2.0 rad/s. A slider in a slot in the disk causes rod 2 to rotate.  When the slider is

Construction of Lacashire boiler: CONSTRUCTION : Consists of boiler shell which contains water and steam. Diameter can vary from 1.75 to 2.75 m and length can be 7.25 - 9 m

ADVANTAGES OF GAS TUNGSTEN ARC WELDING (GTAW) Produces high quality, low distortion welds Free from spatter The process can be used with or without filler wire This

Determine the resultant of the loads: A system of loads acting on beam is shown in the figure given below. Determine the resultant of the loads. Sol.: Let R be resultant

Determine a real root of the equation xlog10 x = 1.2 by regula-falsi method correct to four decimal places.

Question: A 3-phase, 15 kV, 4-pole, cylindrical rotor synchronous generator is connected to infinite bus running at 50 Hz. The synchronous reactance of the machine is X s = 0.

After trial if oil seal found still leaking: Dismantle engine and check crank shaft for run out which should not be more than 0.10 mm.