Cmc complement carry instruction , Electrical Engineering

CMC Complement Carry Instruction

This instruction complements  the carry  flag i .e   if the carry flag  is 1 before the execution of this  instruction it will be reset and if before execution  of this  instruction the carry  flag is 0  it will set after the  execution of this  instructions. The instructions  format is

CMC

Flag  Except  carry no other  flag are affected.

Posted Date: 4/5/2013 2:33:22 AM | Location : United States







Related Discussions:- Cmc complement carry instruction , Assignment Help, Ask Question on Cmc complement carry instruction , Get Answer, Expert's Help, Cmc complement carry instruction Discussions

Write discussion on Cmc complement carry instruction
Your posts are moderated
Related Questions
write a short note on Scale

Q. Explain Emergency Repairs to rail fracture? Emergency Repairs - The fractured rails shall be joined by using the arrangements clamps, fish plates. If the gap at fracture doe

a. Describe the meaning of standing wave ratio. What is the formula for it, if the load is purely resistive? Why is a high value of SWR often undesirable? b. Determine how the c

Q. Show Advantage of digital control system over analog system? Sampled data and digital control offer several advantages over analog systems: • More compact and lightweight

A three-phase, 400-V, wye-connected induction motor takes the full-load current at 45 V with the rotor blocked. The full-load slip is 4%. Calculate the tappings k on a three-phase

What is Global Positioning Satellites (GPS) Global positioning satellite (GPS) systems are used to determine exact location of a car, ship, airplane or any conveyance that trav

Find the minimum rate of sampling that must be used to convert the message into digital form: (a) If an audio message has a spectral extent of 3 kHz. (b) If a television sign

Lenz's law states: 'The direction of an induced e.m.f. is always like that it tends to set up a current opposing the motion or the change of flux responsible for inducing that

if the sheet resistance of a tin oxide is 100 ohms, what is the thickness of the oxide layer?

Q. In order to minimize output voltage offsets in practical op-amp circuits, one provides a dc path from each input terminal to ground, makes each input terminal see the same exter