Circuit with inductive load, Electrical Engineering

Assignment Help:

Circuit with inductive load 

Electromagnetic induction

When a conductor is moved across a magnetic field so as to cut by the lines of force (or flux, an electromotive force (e.m.f) is produced in the conductor. If the conductor forms part of a closed circuit then the e.m.f produced causes an electric current to flow round the circuit. As an e.m.f is induced in the conductor as a result of its movement across the magnetic field. This effect is called a 'electromagnetic induction'.

 


Related Discussions:- Circuit with inductive load

Crt and cro, working principle of crtand block diagram of cro

working principle of crtand block diagram of cro

Explain about stored program control, Q. Explain about Stored Program Contr...

Q. Explain about Stored Program Control? Stored Program Control:   In centralized control, all control equipment is replaced by a single processor which should be quite powerf

Determine the overall power factor, A three-phase, wye-connected, cylindric...

A three-phase, wye-connected, cylindrical-rotor, synchronous motor, with negligible armature resistance and a synchronous reactance of 1.27 per phase, is connected in parallel wit

Why we need biasing, Q. Why we Need biasing? Need for biasing : Baising...

Q. Why we Need biasing? Need for biasing : Baising is necessary to establish the quiescent operating point so that the device operates with the linear region without exceeding

Determine the voltage across resistor, Determine the voltage across the 20-...

Determine the voltage across the 20- resistor in the following circuit of Figure (a) with the application of superposition.

Determine the supply current and the supply voltage, A single phase line ha...

A single phase line has an impedance of 8.4 + j11.2 ?. The line feeds a load consisting of a resistor and an inductor connected in parallel as shown in Figure 1. The load is absorb

How typical dma controller can be interfaced to 8086/8085, Show how a typic...

Show how a typical DMA controller can be interfaced to an 8086/8085 based maximum mode system. For 8088 in maximum mode: The RQ/GT1 and RQ/GT0 pins are utilized to issue DMA

Assmblly language, hi PA DS:1234 = AB PA DS:1235 = CD if i typed mov DX,[...

hi PA DS:1234 = AB PA DS:1235 = CD if i typed mov DX,[1234H] WHAT SHOULD I GET IN DX ?

Types of field-effect transistors, Types of Field-Effect Transistors T...

Types of Field-Effect Transistors The channel of a FET (field-effect transistor) is doped to produce either an N-type semiconductor or a P-type semiconductor. The drain and so

Compute the turns ratio and the winding current ratings, Q. A transformer i...

Q. A transformer is rated 10 kVA, 220:110 V (rms). Consider it an ideal transformer. (a) Compute the turns ratio and the winding current ratings. (b) If a 2-load resistance

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd