Advantages & disadvantages of wired-and connection TTL gates, Computer Engineering

Assignment Help:

What are advantages and disadvantages of TTL gates design with Wired-AND connection ?

Ans.

Advantages and disadvantages

In this IC added logic is performed without extra hardware.
There is an effectual reduction in the fan out of the gate.
In the wired- AND link speed of operation rises.
Power dissipation into low output state in P(O) rises due to reduction in effective collector resistor.
Current dissipation in logic 0 state will rises while two TTL gates with passive pull ups are ANDed through wired logic.
The TTL fates along with missing pull up circuit at the collector are also termed as open collector gates. These are finer for the wired connections.

Related Discussions:- Advantages & disadvantages of wired-and connection TTL gates

Explain classification based on grain size, Explain Classification Based On...

Explain Classification Based On Grain Size This categorization is based on distinguishing the parallelism in a program to be executed on a multiprocessor system. The concept is

Describe the analytical engine by babbage, THE ANALYTICAL ENGINE BY BABBAGE...

THE ANALYTICAL ENGINE BY BABBAGE: It was general use computing device that could be used for performing any types of mathematical operation automatically. It contains the follo

Performance and issues in pipelining-efficiency, Performance and Issues in ...

Performance and Issues in Pipelining Efficiency: The efficiency of a pipeline can be calculated as the ratio of busy time span to the entire time span including the idle time

What are two verification points for use with web sites, 1. Use the Web Sit...

1. Use the Web Site Scan verification point to check the content of your Web site with each revision and make sure that changes have not resulted in defects. 2. Use the Web Sit

Data dictionary, data dictionary for online banking system in software engi...

data dictionary for online banking system in software engineering

Show the frames inside other frames, Q. Show the Frames inside other frames...

Q. Show the Frames inside other frames? Here we would discuss how to divide frames into different frames that is how to put horizontal frames in a vertical one and vice-versa.

What are controls and how to use them, What are controls? How to use them? ...

What are controls? How to use them? Give examples for control. Controls are objects that can be placed in a form. The dissimilar controls are available in the Tool Box. After

Is there a macro recording interface in gimp, Not at this time. With GIMP b...

Not at this time. With GIMP based on GEGL, so that all changes are non-destructive, it will be much easier to execute this feature by just remembering all nodes in given range and

Comparison between motorola processors and intel processors, Comparison bet...

Comparison between Motorola processors and INTEL processors: Intel/AMD processors are really about the same thing. They run the same software and operate in a very similar ma

Define terms setup time and hold time violation, Define setup time and hold...

Define setup time and hold time, what will occur when there is setup time and hold tine violation, how to overcome it? For Synchronous flip-flops, we have particular requiremen

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages