the battery and capacitor combination for power backup, Electrical Engineering

Why do wenot see the battery and capacitor combination for power backup?

Ans) There are "super capacitors" that are used for power backup - they are well-organized for short-term power take-over, but they are leaky and are not good for long term. Batteries tend to expire slowly, more slowly than the leakage on a power backup capacitor, so the capacitor does not do any good. 

 

 

Posted Date: 4/6/2013 2:25:53 AM | Location : United States







Related Discussions:- the battery and capacitor combination for power backup, Assignment Help, Ask Question on the battery and capacitor combination for power backup, Get Answer, Expert's Help, the battery and capacitor combination for power backup Discussions

Write discussion on the battery and capacitor combination for power backup
Your posts are moderated
Related Questions
A 0.1µF capacitor is charged to 200 V before being connected across a 4 kΩ resistor. Determine: (a)  The initial discharge current (b)  The time constant of the circuit

A three-phase, wye-connected, 400-V, four-pole, 60-Hz induction motor has primary leakage mpedance of 1 + j2  and secondary leakage mpedance referred to the primary at standstill

Customer Satisfaction - Issues of Power Supply Customer satisfaction measurement is a systematic process for collecting customer data (e.g. surveys, audits and etc.), analyzin

Q. Show the Overall output limitations of Speed Control? The overall output limitations are as shown in Figure. With base speed defined as the full-field speed of themotor at t

Q. Determine the voltage transfer function of the low pass filter circuit shown in Figure, and find the expression for ω 0 .

consider a single stage ce amplifier with rs=1kohm,r1=50ohm,r2=2kohm,rc=1kohm,rl=1.2kohm,hfe=50,hie=1.1kohm,hoe=25microamp/volt and hre=2.5*10-4

why we use companding

An eight pole dc generator has an armature wound with 768 conductors each capable of carrying 50A without overheating. The emf generated in each conductor is 1.5V. Calculate the th

High-pass T filters: Three-element filters can comprise a 'T' or 'π' topology and in either geometries, a low-pass, band-pass, high-pass, or band-stop characteristic is feasib

Q. Draw and explain a monostable multivibrator ? The monostable configuration consists of two amplifier stages interconnected in such a manner as to possess one stable state. T