find the value of the slip and air gap power, Electrical Engineering

The Thevenin equivalent circuit at the terminals of R2 / S for a 60 hz, 6 pole induction motor is shown below.

a) Find the value of the slip for maximum torque and the maximum torque.

b) For a slip of S = 0.05, find the torque, the speed, the air gap power, the power output and the rotor I2R loss.

587_equivalent circuit.png

Posted Date: 2/15/2013 6:35:33 AM | Location : United States







Related Discussions:- find the value of the slip and air gap power, Assignment Help, Ask Question on find the value of the slip and air gap power, Get Answer, Expert's Help, find the value of the slip and air gap power Discussions

Write discussion on find the value of the slip and air gap power
Your posts are moderated
Related Questions
Guarding Against Loss in Transformers Distribution transformers are expected to convert up to 95-98% of the input power into usable output power. A distribution transformers i

The very basic specifications of a UJT are: Vbb(max) - The maximum interbase voltage that can be applied to the UJT (b) Rbb-the interbase resistance of the UJT (c) n - The

Circuit with capacitive load Capacitors which obey the relationship of equation are linear capacitors, since the potential difference among the conductive surfaces is linearly

Q. Counters are used to realize various dividers in the schematic representation of the digital clock shown in Figure. The blocks labeled "logic array" are logic gate combinations

Explain MMX Technology. Multimedia extensions technology adds 57 newly instructions to the instruction set of the Pentium - 4 microprocessors. The Multimedia extensions techno

Q. Show Common signal-processing operations? Common signal-processing operations include the following: • Amplification to compensate for attenuation • Filtering to reduc

Q. Consider the common-source JFET circuit shown in Figure with ?xed bias. Sketch the sinusoidal variations of drain current, drain voltage, and gate voltage superimposed on the di

I''m trying to design ADC using MAX1198 and DAC using IDAC in Multisim 12 but none of them are working. I need some help in this regard


Explain Medium length lines? Medium length lines cover lines in the range of 50 to 150 miles (80 to 240 km). Due to the increased length of the line, the shunt capacitance of t