describe the mips instructions - computer architecture, Computer Networking

Assignment Help:

1.  Detail for each of the four following MIPS instructions, which actions are being taken at each of their five steps.  Do not forget to mention how and during which steps each instruction updates the program counter.

a)  jalr $s0, $s1

b)  sw $s1, 24($t0)

c)  slt $t0, $s3, $s4

d)  jal 1048576 


Related Discussions:- describe the mips instructions - computer architecture

State the nonselective fading and selective fading, Nonselective fading and...

Nonselective fading and Selective fading Nonselective fading, is a fading in which all frequency methods of the received signal fluctuate in the similar proportions simultaneo

Explain about nonboundary-level masking, Q. Explain about Nonboundary-Level...

Q. Explain about Nonboundary-Level Masking? Nonboundary-Level Masking Bytes in the IP address that correspond to 255 in the mask will be repeated in the subnet addres

How to configure a wireless mac filter - ccna, Configure a Wireless MAC Fil...

Configure a Wireless MAC Filter Step: Add a Mac filter. Navigate back to the web utility page of the router (http://172.17.30.1). Navigate to the Wireless section a

Cisco express forwarding and interface controllers , Cisco Express Forwardi...

Cisco Express Forwarding CEF is a new method of switching that available in IOS, its overcome the drawbacks of fast switching method In IOS packet switching, There are thre

Undesirable sharing - fundamentals of networks, Undesirable Sharing ...

Undesirable Sharing With  the good  comes  the bad  while  networking  allow  the easy  sharing  of useful  information it also  the sharing  of undesirable  data. One sign

command saves the configuration stored in ram to nvram, Which command save...

Which command saves the configuration stored in RAM to NVRAM Ans) copy running-config startup-config is the command which saves the configuration stored in RAM to NVRAM

Explain linear array interconnection networks, Linear Array: This is a most...

Linear Array: This is a most basic interconnection pattern. Processors are connected in a linear one-dimensional array. The first as well as last processors are attached with one a

Whcih is the routing metric used by rip, Routing Information Protocol (RIP)...

Routing Information Protocol (RIP) is a distance vector routing protocol that used hop count as its metric. The maximum hop count is 15, 16 hops are considered unreachable. RIP upd

Explain peer-to-peer networking model, Explain Peer-to-Peer Networking Mode...

Explain Peer-to-Peer Networking Model. A networking model where every workstation has equivalent capabilities and responsibilities is called as peer-to-peer model. There is no

Explain about switching networks, Question 1: a. Differentiate between ...

Question 1: a. Differentiate between the several types of switching networks together with illustration. b. With the help of a diagram explain the two modes of operation un

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd