What will be the time- mean speed and space-mean speed

Assignment Help Civil Engineering
Reference no: EM13306096

Assume you are an observer standing at a point along a three- lane roadway. All vehicles in lane 1 are traveling at 30 mi/ h, all vehicles in lane 2 are traveling at 45 mi/ h, and all vehicles in lane 3 are traveling at 60 mi/ h. There is also a constant spacing of 0.5 mile between vehicles. If you collect spot speed data for all vehicles as they cross your observation point, for 30 minutes, what will be the time- mean speed and space-mean speed for this traffic stream?

Reference no: EM13306096

Questions Cloud

How much heat per second is being removed from the unit : A refrigerator has a surface area of 6.04 m2. It is lined with 0.0885-m-thick insulation whose thermal conductivity is 0.0300 J/(s m C °). How much heat per second is being removed from the unit
Obtain the temperature of the bar : One end of a brass bar is maintained at 305 oC, while the other end is kept at a constant, but lower, temperature. What is the temperature of the bar at a point 0.129 m from the hot end
Find increase in temperature of the brakes : A 768 kg car moving at 27 m/s brakes to a stop. The brakes contain about 16 kg of iron that absorb the energy. What is increase in temperature of the brakes
Determine the velocity and thermal boundary layer thickness : Engine Oil at 60 degrees C flows over a 3m long and 2m wide plate whose temperature is maintained at 20 degrees C with a velocity of 2 m/s. Determine the rate of heat transfer from the entire plate.
What will be the time- mean speed and space-mean speed : Assume you are an observer standing at a point along a three- lane roadway. All vehicles in lane 1 are traveling at 30 mi/ h, all vehicles in lane 2 are traveling at 45 mi/ h, and all vehicles in lane 3 are traveling at 60 mi/ h.
What contributed to the success of the initiative : 1. Discuss an organizational change you have encountered that was successful. What contributed to the success of the initiative? What barriers were overcome to reach success?
Determine what is the departure rate at a parking lot : The arrival rate at a parking lot is 6 veh/ min. Vehicles start arriving at 6: 00 P. M., and when the queue reaches 36 vehicles, service begins. If company policy is that total vehicle delay should be equal to 500 veh-min
What horizontal distance does it travel : If the ball was hit when it was 1.2m above the ground, what horizontal distance does it travel before it lands on the building
What is the velocity of the projectile at the end of process : For simplicity assume the catapult consists of the piston-cylinder geometry (with the piston as the projectile) and that it is positioned horizontally. The steam initially occupies a volume of 1 liter at a pressure of 200 kpa.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what is the radial-horizontal stress at the point

A tire carries a 5,000-lb load and has a pressure of 100 psi. The pavement has a modulus of elasticity of 43,500 psi. A deflection of 0.016 inches is observed at a point on the pavement surface 0.8 inches away from the tire load.

  Calculate the angle a between the vectors a and c

If A cross product B = the vector C, calculate the angle "a" between the vectors A and C and between the angle "b" between the vectors B and C.

  Determine the total dead load

determine the total dead load, per foot of length, each beam must support.

  Calculate the equilibrium concentration of dissolved oxygen

Calculate the equilibrium concentration of dissolved oxygen in 15ºC water at 1atm and again at 2,000m elevation.

  Determine the force in chains ac and ad during the lift

the 3.5mg engine is suspended from a 500 kg spreader beam and hoisted by a crane which gives it an acceleration of 4m/s^2 when it has a velocity of 2m/s. determine the force in chains AC and AD during the lift.

  Difference between dry and moist lapse rate

Explain how the desert air can contain much more h 2 o vapor in the air than the pole, and still a lower humidity than the pole? what causes the difference between dry and moist lapse rate?

  Determine smallest values of c and k for static deflection

the turbopump unit in the engine nominally operates at 7000 rpm, and a result of design issue, the actual thrust provided by the engine oscillates harmonically with an amplitude of 10 KN at the same rotational frequency as the turbopump unit.

  How deep was water on roof at the end of each half period

During a 1.5-hr storm, 1.3 in. of rain fell during the first hour, and 0.4 in. of rain fell during the last half hour. The average flow in the downspouts was 1.7, 3.6, and 3.4 ft3/sec for each of the half-hour periods.

  Determine the time it takes to break the cord

A 3 kg mass is attached to one end of a 1 m long cord. The other end of the cord is attached to the center of a rotating disk (with radius greater than 1 m) that has a very large constant angular velocity.

  How much energy is used per mile of four different cars

We are analysing energy efficiency of four different cars, A (3.2 miles/kwh), B (42 mpg using Clean Diesel), C (22 mpg using corn based ethanol E85), and D (28 mpg using regular gasoline). Now accounting for all of the energy used, including extra..

  Mass of water vapor diffuses through tube

If the water vapor is removed from the upper tank so that the concentration there remains nearly zero, what mass of water vapor diffuses through the tube each hour?

  Problem of coefficient of static friction

The machine part ABC is supported by a frictionless hinge at B and a wedge at C. Knowing that the coefficient of static friction is 0.20 at both surfaces of the wedge, determine:

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd