What is the maximum torque so that the allowable shear

Assignment Help Civil Engineering
Reference no: EM13557108

A hollow circular cylinder made of steel (E =200 GPa, G=77 GPa)is subject to a torque T at one end and is fixed at the other end outer diameter of the rod is 50mm and inner diameter is 44mm. The length of the rod is 60 cm. What is the maximum torque so that the allowable shear stress (250 MPa) is not exceed and twist angle does not exceed 4 degrees

Reference no: EM13557108

Questions Cloud

What is the elongation of a rectangular bar : What is the elongation of a rectangular bar (cross section 2 inch * 2 inch length 4 ft) When it is subjected to an axial load of 80,000 lbs. Assume the material of the bar has the following properties G = 7,700 KSI, V =0.30
Calculate the active and passive pressures at the lower end : A line of sheet piling is driven 4m into a firm clay and retains, on one side, a 3m depth of fill on top of the clay. Water table level is at the surface of the clay. The unit weight of the fill is 18kN/m3 and the saturated unit weight of the clay is..
Determine the factor of safety with respect to shear failure : A footing 3m X 3m carries a pressure of 500 kN/ m2 at a depth of 1m in a sand substrate. The saturated unit weight of the sand is 20 kN/ m3 and the unit weight above the water table is 18 kN/ m3
What is the allowable slope angle if a factor of safety : A cutting 9 m deep is to be excavated in saturated clay of unit weight 19 kN/m3. The design shear strength parameters are cu = 30 kN/ m2 and u = 0. A hard stratum underlies the clay at a depth of 11 m below ground level.
What is the maximum torque so that the allowable shear : A hollow circular cylinder made of steel (E =200 GPa, G=77 GPa)is subject to a torque T at one end and is fixed at the other end outer diameter of the rod is 50mm and inner diameter is 44mm.
What distance will the shoreline recede if the lake shore : Lake Pleasant, AZ, has a surface area of approximately 2,000 ha. The inflow for the month of August is zero. The lake is dammed so that no water leaves the impoundment downstream of the dam
What is the maximum steady speed : A vehicle of mass 2000 kg coasts along a horizontal track against a drag force Fd (in N) on the automobile given by the following Fd=kV^2 where k= 1.25 kg/m and V is the speed in m/s
Convert the pressure to mm of blood assuming the specific : The sphygmomanometer is a device used to measure blood pressure. For a healthy person, the diastolic pressure is about 80mmHg (gage). Convert the pressure to mm of blood assuming the specific gravity of mercury and blood are 13.6 and 1.05, respective..
Determine the average density of the material form : The earth's interior comprises three principle regions: the Core (16.4% of the earth's total volume, density= 11.2 kg/L), the Mantle (82% fo the earth's total volume, density= 4.7 kg/L), and the crust (1.6% of the earth's volume

Reviews

Write a Review

Civil Engineering Questions & Answers

  Engineering ethics and ethical issue

what is the engineering ethics course where to write about any engineering ethical case and discuss the ethical issue?

  Engineering ethics and concept and cases

what is the engineering ethics case related to civil engineering with reference and discuss all the engineering ethics issues which covered the "Engineering etics concepte and cases?

  Transportation and management

In the construction management, there is a lot of procurement route that are necessary and suitable for the construction industry.

  Supporting Investment Promotion: ERNST & YOUNG

Ernst & young is currently providing support to various sectors. In this regards it was felt that if this report is able to document good practices currently being adopted or planned in ceramic sector.

  Personalized Cancer Therapy-A step forward

Cancer is the uncontrolled growth of abnormal cells in the body resulting in tumours that can be benign or malignant (cancerous cells). A proper treatment is necessary to fight with this serious disease.

  Discuss the different environmental companies

Discuss the different agencies, institutes, centers, different environmental companies that are active in UAE.

  Develop a simple urban constructed wetland design

Develop a simple urban constructed wetland design.

  Evaluate company performance in relation to GRI standards

Evaluate company performance in relation to GRI standards and comment on Stigler's theory.

  Water system design

Determine the corresponding error in the computed discharge

  Hydraulic behaviour in open channel

Describe how test flumes and associated equipment are used to assess and confirm hydraulic behaviour in open channel

  Write a paper on steel sustainability

Write a paper on steel sustainability.

  Writing case study about bridge collapse

Writing case study about bridge collapse

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd