Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A chalk core plug having a pore volume of 17.0307 cm3 is fully saturated with reservoir brine. A synthetic oil flood is conducted on this plug. It is found that 12.25 cm3 of reservoir brine was displaced from this plug by the synthetic oil. After reaching this value, no further reservoir brine could be displaced from the core plug. What is the irreducible water saturation of this core plug?
The 800 mm diameter shaft is made of A-36 steel. If it is subjected to the uniform distributed torque of 5kN*m/m, determine the angle of twist of end A with respect to B.
The ½ inch pipe was found to have an average friction factor of 0.0129 and the ¾ pipe had an average friction factor of 0.0209. The length of the pipes between the two manometer connections are 60 inches each.
A river is 6m deep. The riverbed material has a saturated unit weight of 19.5kN/m3. What is the effective vertical stress 12m below the water surface. Assume the water is static and assume a datum at the water surface.
determine the value of Po, as a funciton of H, for these two investment alternatives to be equivalent at an interest rate of i=15% per year.
The beams support one-way slabs, 6 inches thick that span 20 feet center to center. Assume that the beams are 16 inches wide and 24 inches deep. Determine the dead load in pounds per linear foot for the beams, from the concrete structure alone.
What is the procedure standard test method for flash and fire points by cleveland open cup tester if there is animation or video is better....
Determine the magnitude of which will cause the reaction at the bearing to be equal to zero. The bearings are in proper alignment and exert only force reactions on the rod. Set = 600 .
If the column is subjected to an axial compressive force of 800 kN, determine the required diameter of each reinforcing steel bar so that one-third of the load is carried by the steel and two-thirds by the concrete. Assume Esteel= 200 GPa and Econ..
A concrete dam retaining water has a specific weight of concrete of 23.5kn/m3, what is the factor of safety against sliding & overturning and pressure intensity on the base if coefficient of friction is 0.45
Compute the maximum acceptable service load on an A36 steel plate tension member 1/4in.x12in. having a single line of holes parallel to the direction of loading. The load is 25% dead load and 75% live load, and 7/8in. diameter bolts are used.
The distance covered by an aerial photograph is determined by both the focal length of the camera and the tilt of the camera. Although the tilt is usually small, both archaeological and Canadian photographs often use larger tilts.
A tensile test was performed on a metal specimen having a circular cross section with a diameter of 0.50 inch. The gage length is 2 inches. For a load of 13.5 kips, the elongation was 4.66 x 10-3 inches.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd