Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.A syringe is pointed vertically up in the air and a force of 5 lbs is applied to the plunger with a diameter of 0.5 inches. Assuming no losses in the system how high will the stream of water rise above the syringe (assume the height of the needle is negligible).
2.Water at 70oC (? = 1.94 slugs/ft3) flows out of a nozzle (diam. = 1in) with a velocity of 10 ft/s at an individual holding a protective shield. If the water deflects off of the shield perpendicular to the original stream in all directions, what force is required to hold the shield in place?
The average rate of flow measured in a gage at the outlet of the watershed was 30 m^3/sec. Estimate the water losses due to the combined effects of evaporation, transpiration, and infiltration due to ground water.
Outflow of water occurs from a cylindrical tank with a hole at the bottom. Find the height of the water in the tank at any time if the tank has a diameter 2 m, the hole has diameter 1 cm, and the initial height of the water when the hole is opened..
Determine the axial and hoop stresses at the lower end of the vessel. A standpipe 12 ft in diameter and 50 ft tall is being con- structed for use as a storage tank for water with a specific weight of 62.4 lb/ft3. The wall thickness of the vessel is..
Air enters an air - standard Otto cycle with a pressure and temperature of 1 bar and 15 C respectively. The compression ratio is 9 and the bore and stroke of the cylinder are (10 cm, 12 cm).
compute the allowable load on a column with fixed ends if it is 5.45 meters long and made from an S150 x 18.6(S6 x 12.5) beam. The material is ASTM A36 steel. Use the AISC formula.
what policies were implemented during and after WW1,WW2,Cold war?
Water with a static pressure of 1.96kN/M2 flows through an 800 mm diameter pipe. A pitot tube pressure gage in this pipe reads a pressure of 5.88 kN/M2. How do you determine the volume flow rate (Q) of the water? (Q = 1.40 M^3/sec, V=2.79 M/sec)
What is the total moment M due to the force F about point O. Assume that moments acting counterclockwise about point O are positive whereas moments acting clockwise are negative.
The ¼" thick 6061?T6 aluminum bar is subjected to a tensile force of P = 5 kips. b = 4"; c = 1.5"; d = 2.5"; and the fillet radii are 1". a) Determine the maximum stress in the bar. b) What is the lateral strain in the 1.5" wide section
The probability density function, f(t), of the time in hours between storms during the summer in Miami is estimated as f(t) = .014e^(-.014t) if x > 0, f(t) = 0 if x is less than or equal to 0 where t is the time interval between storms in hours.
two sedimentation tanks operate in parallel. The combined flow to the two tanks is .1 m^3/s. the depth of each tank is 2 m and each has a detention time of 4 h.
The flow of water over a weir, can be computed by Q=5.35LH^(3/2), where Q is the volume low rate of water in cubic feet per second, L is the length of weir in feet, and H is the height of water over the weir in feet.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd