Determine the volume and density of the body

Assignment Help Civil Engineering
Reference no: EM13315573

The volume and the average density of an irregularly shaped body are to be determined by using a spring scale. The body weighs 7200 N in air and 4790N in water. Determine the volume and density of the body.

Reference no: EM13315573

Questions Cloud

Calculate what is the porosity of the sand : You have a beaker filled with coarse sand. The capacity of the beaker is 100cm^3. Next, you add to the beaker 40cm^3 of distilled water, filling the water level exactly to the top of the sand.
Vietnam war veteran diagnosed with post-traumatic stress : A Vietnam War veteran diagnosed with post-traumatic stress disorder was employed at the post office. After missing significant time at work for depression related to the PTSD, he requested an accommodation. The post office refused the request on the ..
What bulk volumes of gravel and coarse grained sand require : You are furnished with three sizes of particles. One is gravel with porosity of 0.32, the second is a coarse grained sand with porosity of 0.37, and the third is a fine grained sand with porosity of 0.23.
Determine what effect would water have on the foundation : A water pipe, in diameter id located in a trench 450mm below the center of the slab. The trench running along the length of the slab,300mm wide and 450mm deep, was backfilled with the same soil. If this pipe were to leak, what effect would it have..
Determine the volume and density of the body : The volume and the average density of an irregularly shaped body are to be determined by using a spring scale. The body weighs 7200 N in air and 4790N in water. Determine the volume and density of the body.
Suffered permanent nerve damage at work : Wood suffered permanent nerve damage at work and could no longer drive a ready mix concrete truck, though he could drive other trucks. He asked for a reassignment, but since the employer did not have another job for him, he was terminated.
The department of homeland security rejected : The Department of Homeland Security rejected an employee's application to transfer to a position as a detention enforcement officer on the ground that he had limited vision in one eye because of an earlier injury.
Identify the pros and cons of the partnership : Identify the pros and cons of the partnership as a form of ownership. Discuss funding options for small businesses. Determine and discuss how managerial accounting can help managers with product costing, incremental analysis, and budgeting.
Term to hypothetical case studies : The Unit 3 Assignment requires you to apply the theories, concepts and research that we have covered so far this term to hypothetical case studies. Your answers to the questions should consist of information from the text and supplemental readi..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what tension load is needed to return the length

A 4 meter long steel plate with a rectangular cross section (10mm x 50mm) is resting on a frictionless surface under the sun. The plate temperature is measured to be at 40 degrees Celsius.

  Design settling tank to remove all metal and sand particles

The sand particles range in diameter from 0.04 to 2.0 mm with a specific gravity of 2.65. The wastewater discharge rate is 1400 m3 /d at 20°C. Design a settling tank to remove all the metal and sand particles.

  Determine the peak hour los of richmod highway

A new section of richmod highway is being designed as a six-lane facility (three in each direction) with a two-way, left-turn lane. Determine the peak hour LOS. Assumed base free flow speed = 55mi/h

  What is the maximum bending moment of the beam

A 27ft beam has a uniform load of 6kip/ft. along its entire length. From left to right x=0ft to x=27ft. At x=0 ft it is pinned and at x=18 ft there is a roller. So, the 9 ft end section is cantilevered.

  Find how fast must paddle wheel rotate in that compartment

the water tempearture is 10 degree celusis. how fast must the paddle wheel rotate in that compartment to generate a G(velocity gradient) value 30 s-1

  Discuss method of investigation upgrading of existing gravel

Discuss the method of investigation upgrading of existing gravel road to bituminous paved standard,40km long.

  Determine the spiral curve length to satisfy all requirement

A horizontal curve on a two-lane highway is designed with a 818.51ft radius, 12ft lane, superelevation 6.4%, and a 50mph design speed. Deflection angle is 90 degree. The maximum relative gradient is 0.50.

  Estimate the storm precipitation for station x for condition

Precipitation station X was inoperative for part of a month during which a storm occurred. The respective storm at the three surrounding stations A,B and C were 98,80 and 110mm

  Determine the relative humidity using psychrometric chart

The wet bulb and dry bulb temperatures for humid atmospheric air (at 100 kPa) are measured to be 20 C and 25C respectively. Determine: a. using the psychrometric chart, the relative humidity  b. using the psychrometric chart, the humidity ratio

  Determine the degree of saturation of a sample of soil

Determine the degree of saturation of a sample of soil given that its maximum dry unit weight is 18 kN/m^3 and its optimum moisture content is 12.1%. Assume the Specific Gravity of soil is 2.65.

  Calculate how many minutes it takes for the runner to run

A sprinter runs using a force of 200 N and a power output of 600 W. Calculate how many minutes it takes for the runner to run 1 km.

  Calculate the angle a between the vectors a and c

If A cross product B = the vector C, calculate the angle "a" between the vectors A and C and between the angle "b" between the vectors B and C.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd