Determine the magnitude of the forces and acting at c

Assignment Help Civil Engineering
Reference no: EM13321409

The tube supports the four parallel forces. Determine the magnitude of the forces and acting at C and D so that the equivalent resultant force of the four forces acts at point O.

Reference no: EM13321409

Questions Cloud

It is often said that a good theory is one that can be : It is often said that a good theory is one that can be refuted by an empirical, data-oriented study. Explain why a theory that cannot be evaluated empirically is not a good theory.
Determine the increase in vertical and lateral strains : An Element of soil (sand) behind a retaining wall is subjected to an increase in vertical stress of 60kPa and an increase in lateral stress of 25 kPa. Determine the increase in vertical and lateral strains,
Calculate how deep is the well : A student uses an audio oscillator of adjustable frequency to measure the depth of a water well. He reports hearing two successive resonances at 50.5 Hz and 59.5 Hz. How deep is the well
Explain a mixture of aniline and toluene : Which reagent could be used to separate a mixture of aniline and toluene. A) KMnO4 in H2O B) Dilute NaOH C) Dilute NaHCO3 D) Ag(NH3)2OH E) Dilute HCl
Determine the magnitude of the forces and acting at c : The tube supports the four parallel forces. Determine the magnitude of the forces and acting at C and D so that the equivalent resultant force of the four forces acts at point O.
What should happen to equilibrium gdp on the demand side : In a certain economy, the multiplier for government purchases is 2 and the multiplier for changes in fixed taxes is 1.5. The government then proposes to raise both spending and taxes by $100 billion.
Find through what distance should the object be moved : An object is in front of a converging lens (f = 0.370 m). The magnification of the lens is m = 3.60. Through what distance should the object be moved
Most effective way to carry out the performance appraisals : A key component of working as a manager is to conduct performance appraisals for the employees whom you are managing. You feel that the most effective way to carry out the performance appraisals is to create a written policy that details the way perf..
Define ha is a weak monoprotic acid : If 67.0 mL of 0.119 mol/L NaOH(aq) and 35.0 mL of 0.193 mol/L HA(aq) are mixed, then what is [HA] at equilibrium. Assume that HA is a weak monoprotic acid with pKa=6.23 at 25oC.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the maximum efficiency of the cycle

A geothermal power uses hot water (185oF) as a heat source and the cold water from a close by lake (60oF) as a heat sink. The basic operating system is a close loop ammonia efficiency of the cycle that powers turbine-driven electric generator (100..

  What maximum vertical pressure can be imposed in soil

The soil in a dry granular deposit has an angle of internal friction equal to 35 degrees. At a point in the soil mass where the lateral pressure is 1,000 psf, what maximum vertical pressure can be imposed

  Calculate the change in entropy of a gas of mass

calculate the change in entropy of a gas of mass 8kg when 100 kj of heat energy is supplied to the gas. the temperature of the gas remains constant at 100 c during the heat transfer process

  Estimate the time between when the concentration ratios

The average volumetric water content is 0.40 over the upper 4 meters and 0.30 over the remaining 3 meters above the water table and the net infiltration rate (Darcy velocity) is estimated to be 22 cm/yr.

  Determine the flow rate of the oil

Oil of a specific gravity of 0.75 is flowing through a 6-in pipe under a pressure of 15 psi. If the total energy relative to the datumplate is 8.0 ft below the center of the pipe is 58.6 ft, determine the flow rate of the oil.

  Determine diameter of the shaft at allowable shear stress

The steel uniform shaft has four pulleys attached to it and frictionless bearings at its ends. The pulley at B is connected to a motor that is driving the system. The other three pulleys are consuming the power delivered by Pb .

  What percentage of 1mg/l free chlorine residual would remain

The pH of tap water might be adjusted to the 8 to 9 range to reduce the potential for corrosion of metal pipes in the water distribution system.

  What is the average length of queue

Vehicles arrive at a toll booth with a mean arrival rate of 2 veh/min (the time between arrivals is exponentially distributed). The toll booth operator processes vehicles (collects tolls) at a uniform deterministic rate of one every 20 seconds. Wh..

  Find the torsional moment t for the maxiumum shear stress

The pipe has an outside diameter of 60mm and an inside diameter of 50mm. Find the torsional moment T if the maxiumum shear stress is 80MPa.

  Calculate the mass fractions of the phase present at 700 c

A 50 mg-50 Pb alloy is cooled slowly from 700 C to room temperature, a) Calculate the mass fractions of the phase present at 700 C

  What is future work of the entire cash flow series in year

the cash flow sequence $70+4k, where k is in years and cash flow is in $1000. What is the future work of the entire cash flow series in year 10 at 10% per year

  Determine the lubricant film thickness of flat surface area

A body weighing 120 lb with a flat surface area of 2 ft^2 slides down a lubricated inclined plane making a 30 degree with the horizontal. For a viscosity of 0.002 lb*s/ft^2 and body speed of 3 ft/s, determine the lubricant film thickness.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd