Determine the change in length and the change in diameter

Assignment Help Civil Engineering
Reference no: EM13320726

The acrylic plastic rod is 200mm long and 15mm in diameter. If an axial load of 300N is applied to it, determine the change in its length and the change in its diameter. Ep = 2.70 GPa, Vp = 0.4.

Reference no: EM13320726

Questions Cloud

Find the change in the length of the solenoid : A 6.30 x 10 -5 H solenoid is constructed by wrapping 54 turns of wire around a cylinder with a cross-sectional area of 6.4 x 10-4 m2. find the change in the length of the solenoid
Write brief paragraph summarizing habitat simulation method : Write a brief paragraph summarizing the following Habitat Simulation Method used to analyze environmental flow requirements.
Estimate the values of the spring constant : The suspension system of a 1800 kg automobile "sags" 14 cm when the chassis is placed on it. Estimate the values of the spring constant
By how much does the car body rise on its suspension : A 1000 kg car carrying four 84 kg people travels over a %u201Cwashboard%u201D dirt road with corrugations 3.8 m apart, by how much does the car body rise on its suspension
Determine the change in length and the change in diameter : The acrylic plastic rod is 200mm long and 15mm in diameter. If an axial load of 300N is applied to it, determine the change in its length and the change in its diameter. Ep = 2.70 GPa, Vp = 0.4.
Determine the tension in each wire that are attached : A horizontal circular plate weighing 60-lb is suspended from three wires that are attached to a support at D and form 30 degree angles with the vertical. Determine the tension in each wire.
Explain whether or not if the wire will fracture : Consider a tensile test on polycrystalline copper which has a yield strength of 20,000 PSI and a tensile strength of 40,000PSI. The engineering strain at maximum load in a tensile test was 25%.
Psychological statistics : Psychological Statistics
The simple linear regression model : Where y∗i = a1 · yi + a2, for i = 1, ..., n, and a1 and a2 are known positive constants?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the net change in storage during the year

Determine the net change in storage during the year if local municipality is allowed to take 100 MGD from the reservoir. You may neglect infiltration and seepage from the reservoir. Sketch a mas blance of the reservoir.

  Determine stretch of cord when the system is in equilibrium

The two disks each have a mass of 25kg and are attached at their centers by an elastic cord that has a stiffness of k = 1.6kN/m . Determine the stretch of the cord when the system is in equilibrium

  When would the wells start interfering with each other

one of the wells pumps at a rate of 1240 m3/day. the second well pumps at 850 m3/day.if the aquifer has a transmissivity of 2000 m2/day and a storage coefficient of 4x10^-4, when would the wells start interfering with each other.

  Determine stresses acting on an element oriented at angle

Using the stress transformation equations only,given a stress state where sigma x=105 MPa,sigma y=75 MPa and tau xy=25 MPa, determine the stresses acting on an element oriented at an angle 40 degrees from the x axis.

  What is turbine work output per kilogram of steam circulated

Steam enters the turbine of a single vapor power plant with a pressure of 10 MPa and a temperature of 580 C and expands adiabatically to 6 kPa. The isentropic turbine efficiency is 85%.

  Determine water level rise in an unconfined aquifer produced

Determine the water level rise in an unconfined aquifer produced by a seasonal precipitation of four inches. The aquifers porosity is 20 percent and its specific retention is 9 percent.

  What would be the reduction in length of the sample

A core sample of basalt, 4 inches long and 2 inches in diameter, was tested in unconfined compression. The basalt is known to have a modulus of elasticity = 9.1 x 106 psi.

  What is the final temp and the final mass of air in the tank

an insulated tank is evacuated. Air from the atmosphere at 12 psia and 70 degrees farenheight is allowed to flow into the 100 cubic foot tank. What is the final temp and the final mass of air in the tank just after flow ceases.

  What is the concentration of phenol vapor in the exhaust

A plastic-manufacturing plant emits 1,700 scfm of exhaust at 200oC and 90 kPa. The exhaust (consisting of mostly air) contains 9 ppm phenol vapor (C6H5OH). What is the concentration of phenol vapor in the exhaust in µg/L

  Design a single angle strut connected to a gusset plate

Design a single angle strut connected to a gusset plate to carry 180k n factored load. The length of the strut between center to center intersection is 3m.

  Select the sentence that is punctuated correctly

Select the sentence that is punctuated correctly.

  Design the weir structure in order to accommodate the design

The channel cross section is rectangular in shape,with a bed width of 4 m and Manning n of 0.022. The bed drops by an average of 4.2metres every kilometre. The maximum flow in the channel is equal to 7 m3/s.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd