Calculate the sensitivity of the device

Assignment Help Civil Engineering
Reference no: EM131344585

1. A precision bourdon tube is stated to have an absolute accuracy of ±0.1 percent of full-scale reading of 1 MPa. What is the percent accuracy (uncertainty) when the gage is employed for a differential pressure of 40 kPa in air at 3 atm and 20?C?

2. An assembly of two reservoirs and a small-diameter tube inclined at 30? with the horizontal operates as a micro manometer using water and an oil of specific gravity 0.85 as the two fluids. Calculate the sensitivity of the device expressed in mm/Pa.

Reference no: EM131344585

Questions Cloud

Design the first order rc interface circuit : The switch in Figure P7-45 has been in position B for a long time and is moved to position A at t = 0. Design the first-order RC interface circuit such that vO(t) = 10-10e-2500t V.
Hybridization changes in many chemical reactions : Atom hybridization changes in many chemical reactions. In each of the following reactions, determine what change, if any, occurs to the hybridization of the underlined atom. (a) SO3 + H2O → H2SO4
Could the calibration data be adapted to gas flow : How would one go about calibrating a venturi for liquid measurement? Could the calibration data be adapted to gas flow? If so, how?
Mass of ethanol is consumed by the reaction : Wine goes bad soon after opening because the ethanol (CH3CH2OH) in it reacts with the oxygen gas (O2) from the air to form water (H2O) an acetic acid (CH3COOH).  What mass of ethanol is consumed by the reaction of 5.9g oxygen gas?
Calculate the sensitivity of the device : An assembly of two reservoirs and a small-diameter tube inclined at 30? with the horizontal operates as a micro manometer using water and an oil of specific gravity 0.85 as the two fluids. Calculate the sensitivity of the device expressed in mm/Pa..
Design the first order rc interface circuit : The switch in given Figure has been in position A for a long time and is moved to position B at t = 0. Design the first-order RC interface circuit such that vO(t) = 5e-5000t V.
What is the misinformation being sent out : what is the misinformation being sent out - how are they doing this, or who is doing it?
Identify the questions that must be researched : Identify the questions that must be researched. Determine the hypotheses and variables that must be considered. Identify the ethical considerations that must be considered. Discuss the implications of the ethical considerations.
What mass of oxygen gas is produced by the reaction : Photosynthesis is a chemical in which water (H2O) and carbon dioxide (C2 chemically react to form the simple sugar glucose (C6H12O6) and oxygen (O2).  What mass of oxygen gas is produced by the reaction of 6.21g of water?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find summer values for oxygen demand and oxygen tranfer

A fine-bubble aeration basin has a flow of 21.5 mgd, an influent BOD of 180 mg/l, 31 mg/l of mmonia, and effluent of 10 mg/l. During the winter, the wastewater temperature of 14.8 degrees C does not nitrify.

  Determine the stack-gas so2 concentration in units of micro

The sulfur dioxide (SO2) stack-gas concentration from fossi-fuel combustion is 2 ppmv. Determine the stack-gas SO2 concentration in units of micro grams/m^3. Assume 0C and 1 atm pressure

  What is station and elevation of the lowest point on curve

An equal tangent vertical curve conects an initial grade of -3% and a final grade of +1% and is designed for 60mi/h. The PVI is at station 250+50 and elevation 732 ft. What is the station and elevation of the lowest point on the curve

  Determine the force in chains ac and ad during the lift

the 3.5mg engine is suspended from a 500 kg spreader beam and hoisted by a crane which gives it an acceleration of 4m/s^2 when it has a velocity of 2m/s. determine the force in chains AC and AD during the lift.

  What isthe max increase in temp if the stress in the steel

A square member is composed of a 12 inlong. 1 sq in area steel core with Young's modulus=29*10^6 psi andthermal expansion coefficient of 6.5*10^-6 /deg F

  Determine the unstretched length of spring

Determine the unstretched length of spring AC if a force P = 110 lb causes the angle theta = 60^circ for equilibrium. Cord AB is 2 {rm ft} long. Take k = 50;{rm lb/ft}

  Determine a suitable width for this footing

The footing is located 1 m below the ground surface. The groundwater level is 10 m below the ground surface.

  Describe the present land capability classification system

Describe the present land capability classification system for agriculture in the caribbean, Identifying its limitations and propose recommendations. 200 word limit

  Describe the occurrence of the bauschinger effect

Construct the hysteresis loops for a small amplitude at which only the softer elements yield plastically and for a larger amplitude at which both elements yield plastically.

  Do you expect any current to flow through the wire

Consider a circular copper wire formed by connecting the two ends of a copper wire. The connection point is now heated by a burning candle.

  The hypothetical velocity distribution in a horizontal

the hypothetical velocity distribution in a horizontal rectangular open channel is v0.3y msnbspwhere v is the velocity

  How much power is required to overcome aerodynamic drag

a new sports car has a drag coefficient of 0.30 and a frontal area of 21 ft^2, and is traveling at 119 mi/h. how much power is required to overcome aerodynamic drag if p = 0.002378 slugs/ft^3

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd