Calculate the fraction of vocs in the exhaust

Assignment Help Civil Engineering
Reference no: EM13546776

1.For a circular concrete column in a building with a diameter of 12" and subjected to an axial load of 200 kips, determine the stress exerted on the x-section of that column. What type of stress would it be?

2.Assume that gasoline is burned with 99% efficiency in a car engine, with 1% remaining unburned in the exhaust gases as VOCs. If the engine exhausts 16 kg of gases (MW = 30) for each kg of gasoline (MW = 100), calculate the fraction of VOCs in the exhaust. Give answer in ppm.

Reference no: EM13546776

Questions Cloud

What are the different types of stress that a structural : In order for a shower head to produce a 2.5 gpm flow for 120?F water, what pressure (psi) is needed at the hot water tank if the shower head elevation above the hot water tank is 28 ft? The pipe diameter is 1-in, and assume that the shower head has a..
What is the firm market value capital structure : What is the firm's market value capital structure? (Round your answers to 4 decimal places. (e.g., 32.1616))
The required rate of return is 10%. : The following bonds have a par value of $1,000 and the required rate of return is 10%.
Determine the uniform dead load in kips per linear foot : The estimated uniform dead load for structural steel framing, firproofing, architectural features, floor finish and ceiling tiles equals 24 psf, and for mechanical duct, piping and electrical systems equals 6 psf.
Calculate the fraction of vocs in the exhaust : For a circular concrete column in a building with a diameter of 12" and subjected to an axial load of 200 kips, determine the stress exerted on the x-section of that column. What type of stress would it be?
Bonds make semiannual payments : Vedder, Inc., has 7.6 million shares of common stock outstanding.
A stock has an expected return of 16.8 percent : A stock has an expected return of 16.8 percent, its beta is 1.4, and the expected return on the market is 13 percent. The risk-free rate must be percent. (Do not include the percent sign (%). Round your answer to 2 decimal places.
Determine the flow rate if water temp is 40 : A smooth concrete pipe (1.5-ft diameter) carries water from a resevoir to an industrial treatment plant 1 mile away (5280 ft) and discharges it into the air over a holding tank.
Market value weight of equity : Market value weight of equity ?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate for the water contained in the tank the volume

Water in the amount of 1 lb is contained in a rigid closed tank. Initially the water has a quality of 0.4 at a pressure of 10 lbf/in2. Through a stirrer, work is provided to the water in the tank until the pressure quadruples.

  What maximum force can this person apply with the jack

A person of mass 80kg places all their weight on the pedal of a foot operated hydraulic jack. The diameter of the hydraulic cylinder under foot pedal is 4cm and the diameter of the jack cyclinder is 9cm (Assume g is 9.81 m/s^2)

  Calculate soil moisture using daily precipitation and temp

Calculate soil moisture using daily (or any other scale) precipitation and temperature . Use the Richard's Equation and Darcy's law (Or any theory you like attached to soil moisture content determination ).

  What is tanget distance

A 6 degree 30 minute who curve, whose degree is determine by a 100-ft chord , connect two tangent  that intersect at  an angle of 37 degree 18 minute calculate what is tanget distance?

  What is the maximum height

The height (in meters) of a projectile shot vertically upward from a point 2 m above ground level with an initial velocity of 24.5 m/s is h2+24.5t-4.9t^2 after t seconds. a) When does the projectile reach its maximum height? b) What is the maximum..

  The lenght of measurement should be recordesd as how many

A tape that has an extra foot graduated to tenth outside  the zero mark was used to measure a distance less than a tape lenght. when the rear tapeman held the 52-ft graduation at his point, the head tapeman estamted the reading at  as his end of the ..

  Calculate distance downwind xl at which the plume released

A powerplant is burning coal on a cold, clear winter morning at 8am with a wind speed of 2.6m/s measure at 30m and an inversion layer with its base height of 697m. The effective stack height is 30m.

  Determine the magnitude of the maximum shear stress

A torque of T = 3.00 kN-m will be applied to the hollow thin-walled aluminum alloy section. If the section has a uniform thickness of 4 mm, determine the magnitude of the maximum shear stress developed in the section.

  Which compressor should he buy and why

A diver is planning to salvage a Spanish galleon located in 200 feet of water. He plans to use a diving suit that will be supplied with air from a hose (assume this to be amply sized) connected to a compressor that he will locate in his boat on the s..

  Determine the water level in the upstream manhole that would

A circular manhole cover has a weight of 250 N and a diameter of 1meter. Surcharged conditions (this means the sewer is flowing full)have developed in the sanitary sewer

  Effective thermal capacity in climates

For energy conservation, materials with a high thermal capacity are effective in climates in which the heat flow through the building envelope is:

  Calculate the area of each filter in constructing rapid sand

Estimate the number of filters required and calculate the area of each filter (ft2), assuming that a length-to-width ratio (L:W) of 4:1 is employed in constructing the rapid sand filters and suing a filtration rate of 6 gpm/ft2.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd