### Calculate pressure in point 1 nd density of manometric fluid

Assignment Help Civil Engineering
##### Reference no: EM13302956

A U manometer reads 20 cm air as operating fluid and a given manometric fluid. A single branch closed tube reads 35 cm connected to point 1. If P2 = 1.2 ATM calculate the pressure in point 1 and the density of the manometric fluid.

#### Plot the power input to the compressor and electric power

Plot the power input to the compressor and the electric power saved by using a heat pump rather than electric resistance heating as functions of compressor efficiency, and d

#### Determine the peak discharge that would result no ponds

Suppose a drainage basin has an area of 288 acres with a CN=55(Runoff Coef. of 0.30). Determine the peak discharge (in cfs) that would result from a 6.0in., 24-hr assuming t

#### The third unit of an aircraft hangar project

1. The third unit of an aircraft hangar project was completed in 2700 hours. The fifteenth unit was built in 2100 hours. What is the learning rate (based on doubled units

#### How deep hole in yards would be formed as result of excavatn

The Metrodome's inflatable roof covers 10.0 acres and its interior volume is 60.0x10^3 cubic feet. During construction, 40.0x10^3 cubic yards of concrete, 11.9x10^3 tons of

#### What dimensions were actually laid out for the building

An old and worn 50-ft woven cloth tape is used to lay out and mark the corners of a 75.0 * 150.0 ft building. It is later found that the actual tape length was 50.15 ft. Wha

#### How many tons of water must be added to solids to achieve

Ten tons of a mixture of paper and other compostable materials has a moisture content of 7%. How many tons of water must be added to the solids to achieve a mixture with 50%

#### What is interaction force in ferris wheel framework and seat

The pivot of each 120 kg seat on a Ferris wheel travels in a circle with a 10 m radius, and the Ferris wheelrotates witha rotational speed of 0.1 rad/sec. What is the intera

#### Story building in order for major masonry rehabilitation

Scaffolding is to be constructed on all faces of a six-story building in order for major masonry rehabilitation work to be performed. The exposed surface area of the exterior