Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A mason contracted with a general contractor to build an exterior wall from 8-inch CMUs. The wall is 82 feet long and 8 feet high.16The mason must finish the wall in 3 days and gets paid $4 per block. At the end of day 1, the mason has installed 220 blocks. Her actual cost (including overhead and profit) was $836. Analyze the situation with regard to both the budget and the schedule.
A 3000 lb vehicle has a drag coefficient of 0.32 and a frontal area of 30 ft2. What is the minimum tractive effort required for this vehicle to maintain a 65 mph speed on a 2% upgrade through an air density of 0.002045 slugs/ft3
The center of gravity of the crane is 10 ft from the pin, and the crane weighs 200 lb. What is the tension in the horizontal cable.
The flow rate of water flowing in a 3m wide channel is to be measured with a sharp-crested triangular weir 0.5m above the channel bottom with a notch angle of 60°. If the flow depth upstream from the weir is 1.5m
As the piston is compressed, the pressure also increases by 2000000 Pa. If there is 4 times as many atoms of nitrogen as helium, how many moles of helium are in the cylinder?
If design is needed, use a W-built-up cross section; select the W section and the thickness of the plate. Calculate Cc and use the AISC equations E2-1 and E2-2 to determine the allowable stress for each axis and ultimately the allowable load for t..
the 15,000 kg boxcar A is coasting freely at 1.5 m/s on the horizontal track when it encounters a tank car B having a mass of 12,000 kg and coasting at 0.75 m/s toward it. If the cars meet and couple together
The first pipe of 400mm diameter is 500 m long, the second pipe 600 m long, size 300mm, and the last pipe is 500m long of diameter 200mm. If the elevation difference between two reservoirs is 30m
Air (m=28.97kg/kmol) is uniformly heated at steady state as it flows through a cylindrical constant area duct. It enters the channel uniformly at 2.5atm, 300K and 80m/s and exits at 1.5atm.
A conical tube of length 8 m fixed vertically with its smaller end upwards. The velocity head and pressure head at upper ends are 1.27 m and 2.50 m respectively. The velocity head and pressure head at lower ends are 0.203 m and 5.407 m respectivel..
During a particular 30-day period, the streamflow flowing into a reservoir averaged 5.0 m3/s. Water supply withdrawals from the reservoir averaged 136 mgd. The only other outflow from the reservoir was 9.4 cm of evaporation from the water surface.
If the peak-hour factor is .90 and all of the drivers are regular users, what is the level of the service of this compound-grade freeway segment?
If the hydraulic head in the canal is 100 ft and in the drainage ditch it is 80 ft calculate the maximum mounding height and the mounding distance from the canal that will occur if the farmer irrigates at a rate of 2 acre-ft/acre/year.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd