### A single disc clutch with both sides of the disc effective

Assignment Help Mechanical Engineering
##### Reference no: EM13703083

A single disc clutch with both sides of the disc effective is used to transmit 10 kW power at 900 r.m.p. the axial pressure is limited to 0.085 N/mm^2. If the external diameter of the friction lining is 1.25 times the internal diameter find the required dimension of the friction lining and the axial force exerted by the springs. Assume uniform wear conditions. The coefficient of the friction may be taken as 0.3

#### Estimate the size of the electric motor needed to power

Assume the n in the RosinRammler equation is 1.0, the Bond work index is 400 kWh/ton, and the raw refuse is 80% passing 20 cm. Estimate the size of the electric motor needed

#### What is the area of research

you must explicitly state your research questions and summarise your proposal and rationale. Your introduction must contain the following information: a brief outline of the

#### Calculate the temperature of water exiting absorber tubes

Calculate the temperature of the water exiting the absorber tubes. Calculate the rate of exergy transfer accompanying the heat transferred from the absorber tubes to the water

#### Derive shape functions for a one-dimensional linear element

Derive the shape functions for a one-dimensional linear element in which both the temperature and the heat fluxes should continuously be varying in the element. (Note that d

#### Explain volocity of an airplane was changed

Acceleration was uniform. If it assumed that the acceleration was uniform where the magnitute of the volocity of an airplane was changed from 120mph to 360mph in 6 seconds.

#### Power cycle operating between hot and cold reservoirs

The data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1500 K and 450 K, respectively. For each case, determine whether the cycle ope

#### Air passes through a gas turbine system

Air passes through a gas turbine system at a rate of 4.5kg/s. It enters with a velocity of 150m/s and a specific enthalpy of 3000kJ/kg. At exit, the velocity is 120m/s and the

#### Determine the force of the liquid on the inclined section ab

A cube, 4 ft on a side, weighs 3000 lbf and floats halfsubmerged in an open tank as shown in Fig. For a liquid depth of 10 ft. determine the force of the liquid on the incli

### Write a Review 