Write a note on clampers, Electrical Engineering

Assignment Help:

Q. Write a note on clampers ?

Clamper is a circuit that "clamps" a signal to a different dc level. The different types of clampers are positive negative and biased clampers.

A clamping network must have a capacitor, a diode and a resistive element. The magnitude R and C must be chosen such that the time constant RC is large enough to ensure that the voltage across the capacitor does not discharge significantly during the interval the diode is non- conducting.


Related Discussions:- Write a note on clampers

Determine the total power in balanced delta-connected load, Q. Two wattmete...

Q. Two wattmeters are used, as shown in Figure, to measure the power absorbed by a balanced delta-connected load. Determine the total power in kW, the power factor, and the per-pha

Diode, #quetunnel diode stion..

#quetunnel diode stion..

P-N junction, Explain how a p-n junction functions as a rectifier

Explain how a p-n junction functions as a rectifier

Fulfilled to sustain the oscillations, Q. What are the conditions required ...

Q. What are the conditions required to be fulfilled to sustain the oscillations? The conditions required to be fulfilled to sustain the oscillations are: 1. The loop gain mu

How address and data lines are demultiplexed in 8085, How address and data ...

How address and data lines are demultiplexed in 8085? AD0-AD7 lines are multiplexed and the lower half of address A0-A7 is available only during T1  of the machine cycle. This

State the advanatages of GPS system, Advanatages of GPS system These s...

Advanatages of GPS system These systems have been developed to mimic the knowledge and expertise of an expert in a particular field. For instance: -  prospecting for minera

Find the antenna temperature, Q. If an antenna has an available noise power...

Q. If an antenna has an available noise power of 1.6 × 10 -15 W in a 1-MHz bandwidth, find the antenna temperature.

Discuss dos function call with one example, Discuss DOS function call with ...

Discuss DOS function call with one example. DOS function call: So as to use DOS function calls, always place the function number in register AH and load all other pertinent

EDC, why biasing of bjt transistor is essential?

why biasing of bjt transistor is essential?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd