What is the procedure of binary subtraction, Electrical Engineering

Assignment Help:

Q. What is the procedure of Binary Subtraction?

The Rules of Binary subtraction

  • 0 - 0 = 0
  • 0 - 1 = 1, and borrow 1 from the next more significant bit
  • 1 - 0 = 1
  • 1-1=0

For illustration,

a) 00100101 - 00010001 = 00010100                  0   borrows

  0  0  1 10  0  1  0  1    =    37(base 10)

- 0  0  0  1  0  0  0  1       =    17(base 10)

--------------------------------------------------------------------------------

  0  0  0  1  0  1  0  0    =    20(base 10)

 

b) 00110011 - 00010110 = 00011101              0 10  1   borrows

  0  0  1  1  0 10  1  1    =    51(base 10)

- 0  0  0  1  0  1  1  0       =    22(base 10)

--------------------------------------------------------------------------------

  0  0  0  1  1  1  0  1    =    29(base 10)


Related Discussions:- What is the procedure of binary subtraction

Explain power-system loads, Q. Explain Power-System Loads? Figure repre...

Q. Explain Power-System Loads? Figure represents a one-line (single-line) diagram of a part of a typical three-phase power system. Notice the symbols that are used for generato

Metering techniques, Metering Techniques The techniques of metering co...

Metering Techniques The techniques of metering could be categorized depending upon the voltage at which consumers are fed as: 1. LT (Low Tension) Metering, and 2. HT (Hi

Explain sampling at the nyquist rate, Explain Sampling at the Nyquist Rate?...

Explain Sampling at the Nyquist Rate? What would happen if we reduced the sampling frequency? In the time domain, we would be getting less samples for each period. In the frequ

What are the basic operations of a computer, What are the basic operations ...

What are the basic operations of a computer? The basic operations are READ and WRITE.

Regions of operation, Regions of operation: Applied volta...

Regions of operation: Applied voltages Mode E Forward active E C Saturation E > B

Determine the capacitor and inductor voltages, Experiment • Wire the circu...

Experiment • Wire the circuit shown in Figure. Connect the three oscilloscope channels as shown in Figure. • Select the sinusoidal waveform. Adjust the frequency of the input volt

Armature winding - motor control , Armature Winding In this  winding t...

Armature Winding In this  winding the working  emf is induced by the working  flux. The current  which is  dependent on the load  called current.  The windings  that handle

Schmitt triggering, schmitt triggering with emitter coupled transister

schmitt triggering with emitter coupled transister

Digital electronics logic family, For a given logic family, consider VOL = ...

For a given logic family, consider VOL = 0.25V and VOH = 5 V . For a given circuit, VIL = 0.96 V and VIH = 2.18 V. Find the largest positive-going and largest negative-going nois

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd