What is the draw back of micro programmed control, Computer Engineering

Assignment Help:

What is the draw back of micro programmed control?

It leads to a slower operating speed because of the time it takes to fetch microinstructions from the control store. 

 


Related Discussions:- What is the draw back of micro programmed control

Explain about data registers, Q. Explain about data registers? The data...

Q. Explain about data registers? The data registers are used just for storing intermediate results or data and not for operand address calculation. Some dedicated address re

Recursion, Ask qurecurrion for short noteestion

Ask qurecurrion for short noteestion

What is the use of cache memory, What is the use of cache memory? The u...

What is the use of cache memory? The use of the cache memories solves the memory access problem. In certain, when a cache is included on the same chip as the processor, access

What are the different auto reports available in access, What are the diffe...

What are the different auto reports available in Access? The dissimilar auto reports available in Access are: Columnar AutoReport: makes a report where each row is shown ver

Interconnection network, Interconnection Network Introduction Th...

Interconnection Network Introduction This unit discusses the types and properties of interconnection networks.  In multiprocessor systems, there are multiple I/O modules

Computer architecture by henessy and patterson, what is initial interval an...

what is initial interval and latency in a functional unit(fp) of a pipeline

Meaning of every field in mips instruction, Q. Meaning of every field in MI...

Q. Meaning of every field in MIPS instruction? The meaning of every field in MIPS instruction is given below: op: operation code or opcode rs: First register source

Explain what are user controls, Briefly explain what user controls are and ...

Briefly explain what user controls are and what server controls are and the differences between the two.   An ASP.NET control (sometimes known as a server control) is a server-

Parallel ports - micro-controller, The main I/O used by micro controllers a...

The main I/O used by micro controllers are the parallel ports , the 68HC11F1 has seven  8 bit ports namely Port A,B,C,D,E,F and G . The use of ports depends on the mode configurati

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd