What is the difference between arp and rarp, Computer Networking

Assignment Help:

ARP - Address Resolution Protocol

It is the protocol that traces IP addresses to MAC addresses.

RARP - Reverse Address Resolution Protocol

It is the protocol within the TCP/IP stack that maps MAC addresses to IP addresses.

 


Related Discussions:- What is the difference between arp and rarp

Illustrate 802.11 csma, 802.11 CSMA/CA a) Wait a DIFS time to avoid col...

802.11 CSMA/CA a) Wait a DIFS time to avoid collision b) Send RTS and wait for CTS reply to obtain the use of the Medium (air) c)  Use of SIFS time for control informatio

Modern computer , modern technology in world of 21 century

modern technology in world of 21 century

When the router runs out of buffer space, Source quench is the process wher...

Source quench is the process where the destination router, or end internetworking device will "quench" the date from the "source", or the source router. This usually occurs when th

What is a lan, What is a LAN? LAN stands for Local Area Network. It ref...

What is a LAN? LAN stands for Local Area Network. It refers to the connection among computers and other network devices that are located within a small physical location.

Medium earth orbiting satellite, Medium Earth Orbiting satellite is an orbi...

Medium Earth Orbiting satellite is an orbit which is located just above the few hundred miles to a few thousands above the earth surface. It is of higher advantage than Low orbit s

Telecommunication switching system, if the signal input to an amplifier is ...

if the signal input to an amplifier is 0 dBm what is the power output in mW if the gain of the amplifier is 20 dB ?

Record route ip option, The address recorded by a router should be its outg...

The address recorded by a router should be its outgoing interface. That is, if a router forwards a datagram that has the record route option enabled, and if the datagram arrives at

Low frequency cut-off of the band-pass, Question Approximately what is ...

Question Approximately what is the low frequency cut-off of the band-pass filter shown in the figure?

Two types of transmission technology , What are the two types of Transmissi...

What are the two types of Transmission Technology available in ccna? Ans) Point - to - Point and Broadcast are the Two types of Transmission Technology available in CCNA

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd