What is meant by microcontroller, Electrical Engineering

Assignment Help:

What is meant by microcontroller?

A device which having the microprocessor with integrated peripherals like memory, serial ports, parallel ports, timer/counter, interrupt controller, data acquisition interfaces such as ADC,DAC is known as microcontroller.

 


Related Discussions:- What is meant by microcontroller

A 450 ns eprom won''t work directly with a 5mhz 8088, A 450 ns EPROM won't ...

A 450 ns EPROM won't work directly with a 5MHz 8088.Why? Explain. While the 8088 is operated along with a 5 MHz clock, it permits 460 ns for the memory to access data. Due to t

A, A microstrip antenna system operating at 915MHz must be designed using R...

A microstrip antenna system operating at 915MHz must be designed using Rogers RO3010 substrate with the thickness of 0.635mm.

Draw the equivalent circuits referred to the high-voltage, A single-phase, ...

A single-phase, 50-kVA, 2400:240-V, 60-Hz distribution transformer has the following parameters: Resistance of the 2400-V winding R1 = 0.75 Resistance of the 240-V winding R2

Fraction of the total cross section - interaction processes, Determine and ...

Determine and plot for 5 keV to 100 MeV the fraction of the total cross section due to each of the four interaction processes for      (a) hydrogen,      (b) nitrogen,

Why monitoring and control done, Why Monitoring and control done? Mo...

Why Monitoring and control done? Monitoring and control using microprocessors/computers is often done for the below reasons: - It is safer (faster response to non-standar

Total harmonic distortion, The site 450 kVA load is actually a three-phase,...

The site 450 kVA load is actually a three-phase, six pulse thyristor rectifier feeding a dc bus. Assuming that the voltage waveform at the site 11 kV bus is purely sinusoidal, calc

Obtain the value of rs, Consider and obtain the values for R S , R 2 , R 1 ...

Consider and obtain the values for R S , R 2 , R 1 , and R D . Apply the rule-of-thumb dc design procedure outlined in this section for a JFET with V P = 3V, I DSS = 20 mA, and a

Explain the term full duplex transmission, Explain the term full duplex tra...

Explain the term full duplex transmission. Data can travel in both directions concurrently. There is no require to switch from transmit to receive mode as in half duplex. It's

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd