What is meant by a bus, Electrical Engineering

Assignment Help:

A bus is a collection of conducting lines that carrier's data, address, & control signals.

A bus is two or many wire communication technique. A bus which communicate among two active devices, it may transfer address, data, etc.           

 

 


Related Discussions:- What is meant by a bus

What are cu and neu in 8087, What are CU and NEU in 8087? CU-Control un...

What are CU and NEU in 8087? CU-Control unit NEU- Numeric extension unit. The numeric extension unit implements all the numeric processor instructions whereas the control un

Explain the basic concepts in memory interfacing, Explain the Basic concept...

Explain the Basic concepts in memory interfacing The primary function of memory interfacing is that the microprocessor should be able to read from and write into a given regist

Explain sampling at the nyquist rate, Explain Sampling at the Nyquist Rate?...

Explain Sampling at the Nyquist Rate? What would happen if we reduced the sampling frequency? In the time domain, we would be getting less samples for each period. In the frequ

Determine the equivalent winding resistance, Determine the equivalent windi...

Determine the equivalent winding resistance: A 50 kVA, 2200/110 V, 50 HZ' transformer contain an HV winding resistance of 0.15 Ω and a leakage reactance of 0.45 Ω. The LV wind

Carthode ray oscilloscope, with a simple circuit,explain the construction o...

with a simple circuit,explain the construction of Direct Reading Probe of a cathode ray oscilloscope

Introduction to problem based learning, The Problem Based Learning is an ap...

The Problem Based Learning is an approach to learning prepares the students to engage with challenges similar to real world problems.The VEB3001-Problem Based Learning has been an

What minimum value of coupling resistance, Q. It is desired to have a sag o...

Q. It is desired to have a sag or tilt of no more than 10% when a 50Hz square wave is impressed on an amplifier stage. The output circuit resistance is Rv=1K. What minimum value of

What do you mean by superposition and linearity, Q. What do you mean by Sup...

Q. What do you mean by Superposition and linearity? Mathematically a function is said to be linear if it satisfies two properties: homogeneity (proportionality or scaling) and

Clampers, just to put an assignment Give only short details that are impor...

just to put an assignment Give only short details that are important Specially bised clamper

EEI., explain about heat time curve and cool time curve

explain about heat time curve and cool time curve

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd