What is hybrid sweep, Mechanical Engineering

Assignment Help:

Hybrid Sweep

It combines linear and/or non-linear sweep via set operations. In this case, two point sets are swept in two different directions and the two resulting swept volumes are glued together to form the final object. Invalid solids or non-regular sets may result if the sweeping direction is not chosen properly. Sweeping operations are useful in engineering applications that involve swept volumes in space. Two widely known applications are simulations of material removal due to machining operations and interference detection of moving objects in space.  

 


Related Discussions:- What is hybrid sweep

Find the tension in each wire, A 54 kg chandelier is suspended 1.5 m below ...

A 54 kg chandelier is suspended 1.5 m below a ceiling by 3 wires, each of which has the similar tension and the similar length of 2.0 m (see the drawing). Find the tension in every

Engine oil replacement and top-up, Engine Oil Replacement and Top-up :   Th...

Engine Oil Replacement and Top-up :   The engine oil has to be changed at a periodic interval because after some point of time it loses its viscosity and cooling, anti rust, and se

Force on rigid body - non rigid body, Force on Rigid body - Non Rigid body:...

Force on Rigid body - Non Rigid body: As Rigid body cannot change its shape on application of any force, It will begin moving in the direction of applied force without any

Inspection and testing for coating application, Q. Inspection and testing f...

Q. Inspection and testing for coating application? The Applicator shall perform all inspection and testing necessary to assure that the surface preparation and coating applicat

Determine the chemical formulate for refrigerant, (a) Draw P-H and T-S diag...

(a) Draw P-H and T-S diagrams for following cases : (3) (i) Cycle with superheated vapour before compression. (ii) Cycle with sub-cooling or under-cooling of refrigerant.

Find the velocity and acceleration of the slider, Question: The disk 3 ...

Question: The disk 3 shown in the figure rotates at a constant angular velocity ω 3 = 2.0 rad/s. A slider in a slot in the disk causes rod 2 to rotate.  When the slider is

Identification of defects of coating, Q. Identification of Defects of coati...

Q. Identification of Defects of coating? All holidays and other coating defects, including without limitation primer blister, excess powder mounds, crazed coating, lifted and u

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd