What is bus topology, Computer Networking

Assignment Help:

Q. What is Bus Topology?

 Multipoint configuration

 One cable acts like a backbone to link all devices

 Advantages: Effortlessness of installation and less cabling

 Disadvantages: Difficult reconnection along with fault isolation a fault/break in the bus cable stops all transmission


Related Discussions:- What is bus topology

Analyze snort or pcap data from a public wifi hotspot, The project idea is ...

The project idea is : Analyze Snort or PCAP data from a public WIFI hotspot (describe traffice seen and what it is, protocols, ports, etc). This is what is expected. Initially r

Wireless Networks, Is a complete OSI/TCPIP network architecture available i...

Is a complete OSI/TCPIP network architecture available in MATLAB?

What is frequency diversity, What is Frequency diversity Due to the tra...

What is Frequency diversity Due to the transmission is spread out over a larger bandwidth, frequency-dependent transmission impairments, like as noise bursts and selective fadi

Difference among flow control and error control, What is the difference am...

What is the difference among  flow control and error control?    Ans) Flow control: adjust and confirm data flow rate for successful transmission. Error Control: a method to

What is framing, What is Framing? Framing in the data link layer divide...

What is Framing? Framing in the data link layer divides a message from one source to a destination, or from other messages to other destinations, by adding a sender address and

Speed up with metrics for performance evaluation, Speed Up:- Speed up i...

Speed Up:- Speed up is the ratio of the time required to implement a given program using a definite algorithm on a machine with one processor (i.e. T (1) (where n=1)) to the ti

Define choke packet and implicit congestion signalling, Define Choke packet...

Define Choke packet and Implicit congestion signalling Choke packet: A choke packet is a control packet produced at a congested node and transmitted back to a source node to co

Determine the signal bandwidth and the amplitudes, 1. A low voltage digital...

1. A low voltage digital device has a low state of 0 V and a high state of 1.8 V. It generates a signal train of high pulses at a rate of 1 MHz, these pulses having a 10 ns width a

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd