What is a positive displacement pump, Mechanical Engineering

Assignment Help:

A positive displacement pump is a liquid or gas to move by trapping a fixed amount of fluid or gas and then forcing (displacing) that trapped volume into the discharge pipe. Positive displacement pumps can be further specified as either rotary-type (for example the rotary vane) or lobe pumps same to oil pumps used in car engines. These pumps give a non-pulsating output or displacement unlike the reciprocating pumps. Hence, they are known as positive displacement pumps.

 


Related Discussions:- What is a positive displacement pump

Example of change of enthalpy, Example of change of enthalpy: Q 0.5...

Example of change of enthalpy: Q 0.5kg/s of a fluid flows in steady state process. The properties of fluid at the entrance are measured as p 1 = 1.4bar, density = 2.5k

Determine tension in the rope - motion of lift, Determine tension in the ro...

Determine tension in the rope: An elevator cage of mineshaft, weighing 8KN when, is lifted or lowered by means of wire rope. Once man weighing 600N entered it and lowered wit

Define strain, Define strain: Sol. : STRAIN(e) : When the body is sub...

Define strain: Sol. : STRAIN(e) : When the body is subjected to some external force, there is some change in dimension of body. The ratio between change in the dimension of b

#totto cycleitle.., for an otto cycle, compression ratio=8.5:1,air inlet=15...

for an otto cycle, compression ratio=8.5:1,air inlet=15degree celsius and pressure=101.3kpa, maximum cycle temperature= 1800degree celsius, what is temperature after compression,te

Evaluate the centroid of an area, Evaluate the centroid of an area: De...

Evaluate the centroid of an area: Determine the centroid of an area shown in Figure (a). Solution This problem may be attempted in two ways as illustrated in Figu

Find cutting speed for prolonging tool life , Find Cutting Speed for Prolon...

Find Cutting Speed for Prolonging Tool Life A form tool machining at 24 m/minute requires re-sharpening after 30 minutes. What should be the cutting speed for prolonging tool

Test, test test teste teste teste tester

test test teste teste teste tester

Material science, what is the main process to get steel hard

what is the main process to get steel hard

Computer integrated manufacturing, methods involved in grouping the parts i...

methods involved in grouping the parts into families?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd