What do you mean by continuous signals, Electrical Engineering

Assignment Help:

Q. What do you mean by Continuous signals?

Continuous signals are described by time functionswhich are defined for all values of t (a continuous variable). Commercial broadcast systems, analog computers, and various control and instrumentation systems process continuous signals. The information processed in analog systems is contained in the time function which defines the signal. Analog systems are often thought of as performing signal processing in the frequency domain.

556_Continuous signals.png


Related Discussions:- What do you mean by continuous signals

R = 10 ohms VB = 5V V1 is the sinusoidal wave having, Ask questionDraw the ...

Ask questionDraw the following circuits on the PROTEUS and check the output waveform on oscilloscope #Minimum 100 words accepted#

Explain working of single-phase induction motors, Q. Explain working of Sin...

Q. Explain working of Single-Phase Induction Motors? For reasons of simplicity and cost, a single-phase power supply is universally preferred for fractional-horsepower motors.

Express the storedmagnetic energy, A relay is essentially an electromechani...

A relay is essentially an electromechanical switch that opens and closes electrical contacts. A simplified relay is represented in Figure. It is required to keep the fenomagnetic p

Selection of proper fuse in electricity and gas hazards, Selection of Prope...

Selection of Proper Fuse : Fuse is a safety device or a wire of metal in a cut-out which may be fused by an excessive current. The current drawn by an appliance is restricted by t

Give the register organization of 8257, Give the register organization of 8...

Give the register organization of 8257? The 8257 do the DMA operation over four independent DMA channels. Each of the four channels of 8257 has a couple of two 16-bit registers

What do you mean by amplifier block, Q. What do you mean by Amplifier block...

Q. What do you mean by Amplifier block? An amplifier can be modeled as a two-port device, that is, a box with two pairs of terminals designated as input and output, as shown in

add instruction, ADD Instruction This  instruction use to add  content...

ADD Instruction This  instruction use to add  contents of any  register or memory  location with the  contents of accumulator. There are two  formats for ADD  instruction to ad

Industrial Automation, 1. Write the Boolean expression and draw the gate lo...

1. Write the Boolean expression and draw the gate logic diagram and typical PLC ladder logic diagram for a control system wherein a fan is to run only when all of the following con

Dc motor starting, DC Motor Starting When voltage is applied to the arm...

DC Motor Starting When voltage is applied to the armature of a dcmotorwith the rotor stationary, no emf is generated and the armature current is limited only by the internal ar

Compute the load power factor, Considering Figure, let balanced positive-se...

Considering Figure, let balanced positive-sequence, three-phase voltages with ¯V AB = 100√3 0° V (rms) be applied to terminals A, B, and C. The three-phase wye-connected balanced

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd