Use scattered lighting for underwater inspection of bridge, Civil Engineering

Assignment Help:

Define Use of scattered lighting for Underwater inspection of Bridge

In this arrangement, a very high powered, tight beam spot light (beam angle less than 10°) is used. The lamp is directed near but not at the object. The object is illuminated by scattered light from the high power lamp beam along the light path. Because the illuminating light is scattered and diffused, the effect of backscatter tends to be much reduced as there is little directly reflected light.

 

1960_Use of scattered lighting.png

 


Related Discussions:- Use scattered lighting for underwater inspection of bridge

Examine the state of stress at the junction of flange, Examine the state of...

Examine the state of stress at the junction of flange: A beam of I-section as shown in Figure (a) is subjected to a bending moment of 84.928 kN m and a shear force of 106.1 kN

Concrete, what are the appropriate methods of concreting

what are the appropriate methods of concreting

Determine the allowable bearing pressure of the sand, Two load tests were c...

Two load tests were conducted at a site-one with a 0.5 m square test plate and the other with a 1.0 m square test plate. For a settlement of 25 mm, the loads were found to be 60 kN

The right triangle, a lighthouse standing on the cliff observed from two op...

a lighthouse standing on the cliff observed from two open boats A and B in a vertical plane thourgh the lighthouse.the angle of elevation of the top of the lighthouse viewed from B

What do you mean by ggbs – cement replacement, Q. What do you mean by GGBS ...

Q. What do you mean by GGBS – cement replacement? From structural point of view GGBS replacement enhances higher durability, lower heat of hydration and higher resistance to su

Explain the principle of working of shock transmission unit, Explain the Pr...

Explain the Principle of Working of Shock Transmission Unit? The STU consists of a machined cylinder with a transmission rod that is connected at one end to the structure and a

How can we reduced frictional losses, How can we reduced frictional losses ...

How can we reduced frictional losses Frictional losses can be reduced by several methods, such as : (a) Over-tensioning the tendons by an amount equal to the maximum frictio

Distomat, short note about characteristics of distomat

short note about characteristics of distomat

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd