Use of speaker, Electrical Engineering

Assignment Help:

Q. Use of Speaker?

Speaker:Basically speaker is the receiver for telephone. Speaker converts electrical signals received from local loop to acoustical signals(sound waves) that can be heard and understood by a human being. Speaker is connected to local loop through hybrid network. Speaker is typically enclosed in handset of telephone along with the microphone.


Related Discussions:- Use of speaker

Draw the block diagram of phase cancellation ssb generator, a. The antenna ...

a. The antenna current of an AM broadcast transmitter, modulated to depth of 40% by an audio sine wave is 11 amp. It enhances to 12 amp as a result of simultaneous modulation by an

Sphl load stack pointer with hl instruction, SPHL Load Stack  pointer with...

SPHL Load Stack  pointer with HL Instruction This instruction  copies  the contents of HL register  pair  the stack pointer register. The instruction format is             S

Compute the power factor for zero voltage regulation, A three - phase,wye -...

A three - phase,wye - connected, 2500-kVA, 6600- V, 60-Hz turboalternator has a per-phase synchronous reactance and an armature resistance of 10.4 and 0.071 , respectively. Comput

DECISIEN FEEDBACK, Do you provide me matlab code for comparison the perfor...

Do you provide me matlab code for comparison the performance of decision feedback equalizer over MLSE

Find the duty ratio and neglecting friction and windage, A 440-V, 60-Hz, si...

A 440-V, 60-Hz, six-pole, wye-connected, wound-rotor induction motor with a full-load speed of 1170 r/min has the following per-phase parameters referred to the stator:R 1 = R' 2

Microprocessor system, A burglar alarm system is controlled by a microproce...

A burglar alarm system is controlled by a microprocessor system. The system has three independent circuit each consisting of 7 passive infra red sensors. The controller can be prog

Encoder, decimal to BCD code encoder active low

decimal to BCD code encoder active low

Concept of flux density, We can illustrate the direction and strength of a ...

We can illustrate the direction and strength of a magnetic field by means of drawing 'flux lines'. These have arrows to show the direction of the magnetic field at any point and th

Pn-junction under bias, Q. pn-Junction under Bias? Let an external sour...

Q. pn-Junction under Bias? Let an external source be connected between the p- and n-regions, as shown in Figure (a). (b) shows the circuit representation of the pn-junction or

Find the initial and final values of the armature current, A 10-hp, 230-V, ...

A 10-hp, 230-V, 500-r/min shunt motor, having a full-load armature current of 37 A, is started with a four-point starter. The resistance of the armature circuit, including the inte

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd