Types of holons, Mechanical Engineering

Assignment Help:

Types of Holons

The four major types of holons are:

  • Order holons
  • Product holons
  • Resource holons
  • Staff holons

Considering the cooperative aspect of these holons, this is essential that they are integrated in to Holonic information network through the application and information support to suit the Holonic system needs. Resource holons, Order holons, Product holons are major types while Staff holons serves as complementary holon to the basic individual. These four types of holon decide the whole taxonomy of the Holonic Manufacturing System. Integration of these four types of holons gives substantial information associated to the development of Holonic manufacturing control architecture. The interaction of such holons is identified by using the integration and the communication protocols. These are used to form a well-coordinated autonomous agent network. These holons' details with respect to accountability and responsibility of the system are illustrated as given below:

 


Related Discussions:- Types of holons

Auto - associative network, We seek to test if an auto-associative network ...

We seek to test if an auto-associative network is capable of recalling certain memories. Here you will test if patterns can be completed or recovered. You are given a single patter

Annealing temp, hiw can i fix the maximum temp of the aluminium

hiw can i fix the maximum temp of the aluminium

Aerospace engineering, An airfoil of surface area 1.5 ft2 is tested for lif...

An airfoil of surface area 1.5 ft2 is tested for lift L in a wind tunnel. At an angle of attack of 7° with standard air of density 0.0024 slugs/ft3 at a speed of 90 ft/sec, the lif

example of alteration of position and reference line method, Example of Al...

Example of Alteration of Position and Reference Line Method: Sketch the projections of a pentagonal prism edge of the base 50 millimeter long and height 90 millimeter, the axi

I-Section, An unsymmetrical I-Section as shown in figure below. If maximum ...

An unsymmetrical I-Section as shown in figure below. If maximum bending stress is not extend more than 40MPa in the section than find out the moment which it can bear

Draw the p-h diagram for the vapour compression cycle, Draw the P-h and T-S...

Draw the P-h and T-S diagram for the vapour compression cycle when the vapour after compression is : (i) wet region (ii) dry saturated

Driving mechanism-knurl or friction drive-gear drive, Driving mechanism ...

Driving mechanism   I). Knurl or Friction Drive :  This has either the upper or lower electrode (or both) driven by a friction wheel on the periphery of the electrode. A co

Estimate what fraction of heat loss by the fin, A tube assembly constructed...

A tube assembly constructed of Cu with an inside diameter of 1.25 cm, wall thickness of 0.8 mm and circumferential fins around the periphery. The fins have thickness of 3 mm, and a

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd