Optimization, consider the following LPP max z=9x1+8x2+5x3 subject to 2x1+3...

consider the following LPP max z=9x1+8x2+5x3 subject to 2x1+3x2+x3 5x1+4x2+3x3 x1,x2,x3>_0 (a)solve using simlex method (b)hence using the sesitivity analysis,find the new optima

Describe electron beam welding, Discuss any three of the following:- (i)...

Discuss any three of the following:- (i) Electron Beam Welding (ii) Friction Welding (iii) Thermit Welding (iv) Gas Welding Give their advantages, Limitations, and a

Nature of bending stress, According to the explanation, why reverse will ha...

According to the explanation, why reverse will happen in the case of cantilevers? ( that is, tensile stresses will be induced in upper layers and compressive stresses will be induc

What are the reasons behind poor pick-up of motor cycle, (a) Why does engin...

(a) Why does engine overheat and what will happen if engine overheats? (b) Why engine does not start in wet or damp weather? (c) What may be the causes if engine dose not sta

Design the keys - shear keys, Design the keys - Shear Keys: A solid ci...

Design the keys - Shear Keys: A solid circular shaft is to transmit 200 kN at 200 rpm. If the maximum shear stress is not to exceed 80 n/mm 2 design the shaft. Design the key

Determine thermal efficiency of the cycle, (a) Compare otto, Diesel and Dua...

(a) Compare otto, Diesel and Dual combustion cycle on the basis of compression ratio, same compression ration and same Heat input and constant maximum pressure and heat supplied.

Fatigue crack propagation, Fatigue crack propagation: If it is assumed...

Fatigue crack propagation: If it is assumed that no plastic deformation occurs around crack tip and law of fatigue crack propagation for place of above Example is da/dN =  10

Poisionsratio,

Ideal speed circuit, Ideal Speed Circuit ( 36 to 40 kmph ) : Motorcycle i...

Ideal Speed Circuit ( 36 to 40 kmph ) : Motorcycle is brought into this condition by raising the throttle valve and an incorporated jet needle. The air enters through the main pa

Need of alternate conceptual system design, What do you mean by Management ...

What do you mean by Management Information System (MIS)? What are its advantages ? Also give the qualities of an ideal MIS. What is the basic need of alternate conceptual system