transmission and distribution, Electrical Engineering

Assignment Help:
A three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of 11 m as shown in Figure 1(a). The conductors have a diameter of 3.625 cm and a GMR of 1.439 cm. The line is to be replaced by a three-conductor bundle. The new conductors have a diameter of 2.1793 cm and GMR of 0.8839 cm. The new line will also have a flat horizontal configuration, but it is to be operated at a higher voltage and therefore the phase spacing is increased to 14 m as measured from the centre of the bundles as shown in Figure 1(b). The spacing between the conductors in the bundle is 45 cm. Determine:
(a) The percentage change in the inductance.
(b) The percentage change in the capacitance.
Figure 1(a)
Figure 1(

Related Discussions:- transmission and distribution

Explain frequency response curve of a rc coupled amplifier, Q. Explain the...

Q. Explain the frequency response curve of a  RC coupled amplifier The frequency response curve of a typical RC coupled Amplifier is shown below: In mid frequency range

What is barkhausen criterion, Q. What is Barkhausen criterion? Why is the v...

Q. What is Barkhausen criterion? Why is the value of Ab kept slightly greater than 1? The condition |Ab| = 1 is called the Barkhausen criterion. It implies that when |Ab| = 1,

Chopper configuration - power supplies , Chopper Configuration Choppe...

Chopper Configuration Chopper are classified  in five  different classes according  to their operating capability in particular quadrant. The  current  directions and voltage

Illustrate breakpoint analysis, Q. Illustrate Breakpoint Analysis? When...

Q. Illustrate Breakpoint Analysis? When a circuit consists of two or more ideal diodes, it will have several distinct operating conditions resulting from the off and on states

Compute l per unit length for plate, Q. The inductance per unit length in H...

Q. The inductance per unit length in H/mfor parallel plate in?nitely long conductors in air is given by L = µ 0 d/w = 4π×10 -7 d/w, where d and w are inmeters.Compute L (per unit

Speed control of dc series motor - motor control , Speed Control of DC Seri...

Speed Control of DC Series Motor A half  wave  circuit  for the  speed  control of DC  series motor is  shown in figure and corresponding wave from  is shown  in figure  consis

Commercial losses in electrical systems, Commercial Losses in Electrical Sy...

Commercial Losses in Electrical Systems Commercial losses are caused by pilferage, theft, defective meters, and errors in meter reading and in estimating un-metered supply of

Obtain the node voltages and current through each element, Q. For the circu...

Q. For the circuit shown in Figure, develop and execute a PSpice program to obtain the node voltages and the current through each element.

Visible light communication project, I need a project in visible light comm...

I need a project in visible light communication with matlab design.

Describe the two core-excited states, Using the optimized 6-311G(d,p) geome...

Using the optimized 6-311G(d,p) geometry determined in question 1, perform the following equivalent core calculations for any two inequivalent carbons of butadiene: (a) Equivale

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd