transformer cooling, Electrical Engineering

Assignment Help:
An oil-filled transformer has a c.m.r. of 500 kVA which allows it to run
continuously in an ambient of 35°C with an oil temperature rise of
50°C. The transformer has a time constant of 1.5. hours and the ratio of
copper losses to iron losses at c.m.r. is 1.5:1.
After switch-on, the transformer supplies a load of 600 kVA for one
hour and the load then rises to 750 kVA. Calculate the period of time
that the transformer can supply this load without exceeding its rated
maximum temperature. Sketch the heating curves for the two loads.

Related Discussions:- transformer cooling

Explain the suitability of copper, Explain  the  suitability  of  coppe...

Explain  the  suitability  of  copper that  is  used  as  electrical  conducting materials. Copper : Pure annealed is utilized for the winding of electrical machines. High pur

Find the maximum frequency of an output sine wave, Find the maximum frequen...

Find the maximum frequency of an output sine wave which can be produced at an amplitude of 1.5 V if the op-amp slew rate is 0.5 V/µs.

Electronic devices and circuits, Determine the change in IC from 25ºC to 17...

Determine the change in IC from 25ºC to 175ºC for the transistor defined in this table for fixed-bias with RB = 240 k and = 100 due to the S(VBE) stability factor.

Why monitoring and control done, Why Monitoring and control done? Mo...

Why Monitoring and control done? Monitoring and control using microprocessors/computers is often done for the below reasons: - It is safer (faster response to non-standar

What are the precautions to be taken, What are the precautions to be taken ...

What are the precautions to be taken before basic work on electrical installations? Ans: Before starting any electrical works on installations disconnect the power supply to

Determine harmonic factor hf of the input current, Q. Consider a full-wave ...

Q. Consider a full-wave single-phase bridge recti?er circuit with dc motor load, as shown in Figure (a). Let the transformer turns ratio be unity. Let the load be such that the

Lhld load hl pair direct instruction, LHLD  Load  HL Pair Direct  Instru...

LHLD  Load  HL Pair Direct  Instruction This  instruction is used to copy the  content  of memory  location specified  by opened  in register L  and copy the content of next  m

Show procedure of divide the decimal number by 2, Q. Show procedure of divi...

Q. Show procedure of divide the decimal number by 2? For this procedure (method), divide the decimal number by 2, if the remainder is 0, on the side write down a 0. If the rema

The octal butters 74ls244, The Octal Butters 74LS244 It has  two group ...

The Octal Butters 74LS244 It has  two group  of four  buffer with  no inverted tri state  output ,  controlled by  two active  low  enable lines  (1G and 2G)  as shown in figur

Show effects of saliency and saturation, Q. Show Effects of Saliency and Sa...

Q. Show Effects of Saliency and Saturation? Because of saliency, the reactancemeasured at the terminals of a salient-pole synchronousmachine as opposed to a cylindrical-rotor m

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd