The value of resistance in the regulator circuit, Electrical Engineering

Assignment Help:

A zener regulator consumes a zener diode with an internal zener resistance of 5 ohm and the value of resistance in the regulator circuit is 82 ohm. If the supply voltage alters by 1 Volt what will be the change in output voltage


Related Discussions:- The value of resistance in the regulator circuit

Transparent latch d flip flop, Transparent latch D flip  Flop A typica...

Transparent latch D flip  Flop A typical  example  of this  type of D flop  is 7475 shown  in figure when CLK  connected is enable signal is high and the flip  flop  is enabled

Diode transistor logic gate, A circuit realization of a NAND gate will now ...

A circuit realization of a NAND gate will now be developed. By connecting NAND gates together in various ways, one can synthesize other gates and flip-flops. Thus in principle, a s

What is meant by a bus, A bus is a collection of conducting lines that carr...

A bus is a collection of conducting lines that carrier's data, address, & control signals. A bus is two or many wire communication technique. A bus which communicate among two

Automatic voltage booster, Automatic Voltage Booster The functioning o...

Automatic Voltage Booster The functioning of Automatic Voltage Booster (AVB) is same to in which of the series capacitor. Automatic Voltage Booster is an on-load tap changer.

What is centralized spc, Q. What is centralized SPC? In centralized con...

Q. What is centralized SPC? In centralized control, all control equipment is replaced by a single processor which should be quite powerful. It should be capable of processing 1

Mr Aucamp , How can I get an oscillator to genarate a sinusoid instead of a...

How can I get an oscillator to genarate a sinusoid instead of a triangle wave

Transistors, what is transistor how it works?

what is transistor how it works?

Explain the signals hold and sid, Explain the signals HOLD, READY and SID ...

Explain the signals HOLD, READY and SID HOLD indicates that a peripheral such as DMA controller is requesting the use of address bus, data bus and control bus. READY is used to

Current and voltage polarity, why Direct current flow through semiconductor...

why Direct current flow through semiconductors but alternating current cannot flow?

What is i/o mapping, What is I/O mapping? The assignment of addresses t...

What is I/O mapping? The assignment of addresses to various I/O devices in the memory chip is known as I/O mapping.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd