The radial dimension commands, Mechanical Engineering

Assignment Help:

The Radial Dimension Commands

There are 2 main radial dimension commands, DIMDIAMETER & DIMRADIUS. Both commands result in  similar looking dimension so AutoCAD automatically inserts a command "R" to indicate a radius and the dimension symbol to indicate a dimension.The Diameter & Radius commands are supplemented by the DIMCENTER command which can be used to add further center mark to any circle or arc. The DIMDIAMETER and DIMRADIUS commands dont  automatically draw a center mark.

                                                    816_The Radial Dimension Commands.png


Related Discussions:- The radial dimension commands

Austempering, Austempering: The component to be hardened is initialy ...

Austempering: The component to be hardened is initialy austenised and after that quenched into a lead or salt bath held at just over the martensite transformation temperature

Design evacuation systems for plant, Q. Design evacuation systems for plant...

Q. Design evacuation systems for plant? The plant will have designated Muster areas where personnel can go during an emergency and be accounted for and from which they can then

Control cables and rubber parts, Control Cables: Never bend or distort con...

Control Cables: Never bend or distort control cables. This will lead to stiff operation and premature cable failure. Rubber Parts: Beware of parts containing O-rings or oil s

BEEE, What is alternating quantity?

What is alternating quantity?

Data translation requirements, Data translation requirements: An appar...

Data translation requirements: An apparent indication that CAD data translation is now an accepted part of the complex mechanical design world is the emerging trend towards bu

Explain external pressure design, Q. Explain External Pressure Design? ...

Q. Explain External Pressure Design? Determine requirements for external pressure based on the expected operation of the vessel, and add a suitable operating margin to establis

What is air intakes, Q. What is Air Intakes? Air is drawn from the atmo...

Q. What is Air Intakes? Air is drawn from the atmosphere for a variety of process and equipment uses, including: • Combustion air (fired heaters, boilers, gas turbines, int

Tributary lateral load, Tributary lateral load:   The question is on a f...

Tributary lateral load:   The question is on a fictitious 1965 building in Albany, NY. It was designed using the 1964 State Building Construction Code, in which Allowable Stress

Determine the isentropic flow through the nozzle, Determine the isentropic ...

Determine the isentropic flow through the nozzle: In an isentropic flow through the nozzle, air flows at rate of 600Kg/hr. At inlet to the nozzle, the pressure is 2Mpa and te

Vibration, On the Moodle site just below the assignment you will find data ...

On the Moodle site just below the assignment you will find data from a slow sine sweep test conducted on a car on a "four-post" road simulator for the frequency range 0 to 20 Hz in

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd