Stress-strain curves represents a soft and weak material, Civil Engineering

Assignment Help:

Which of the following stress-strain curves represents a soft and weak material?

 

911_stress-strain curves represents a soft and weak material.png

Solution: As depicted, stress is on the y-axis while the x-axis represents strain.When "a" is compared to "b", the stress is less.  Comparatively, both c and d are characteristically brittle and fail relatively quickly when stress is applied (for example, concrete). 

answer is “a” --- “soft and weak”.

 


Related Discussions:- Stress-strain curves represents a soft and weak material

Flow, what is maximum flood level

what is maximum flood level

Define categories of scaling-underwater inspection of bridge, Define the Ca...

Define the Categories of Scaling? Scaling is classified into following three categories: i. Light scale - loss of surface mortar up to 5 mm deep, with surface exposure of co

What is the meaning of wrapped splices, What is the meaning of Wrapped spli...

What is the meaning of Wrapped splices In the Wrapped splices, tendon wires are wrapped with small diameter high-tension wires along their lengths with the help of  wire windin

Find out the joint distribution, Find out the joint distribution: Let ...

Find out the joint distribution: Let X I and X 2 be two independent random variables each distributed uniformly in the interval [ 0, a ], where a > 0 is a constant. Find out

Device of cavitations in pipes and drains, Question What is device of cavit...

Question What is device of cavitations in pipes and drains ? Answer Cavitations refer to arrangement of air foam in fluid in low-pressure condition that is lower than satura

Distomat, write short note on distomat with applications

write short note on distomat with applications

Explain different types of texture and structure of soils, (a) Relate dissi...

(a) Relate dissimilar formations of soils to the geological aspects. (b) Explain different types of texture and structure of soils. (c) Bring out the typical characteristics

Diferential equations, show that Y = 4e2x - 2e-3x is a solution of initia...

show that Y = 4e2x - 2e-3x is a solution of initial-value problem (d2y)/(dx2)+ (dy)/(dx) - 6y=0 ; y(0)=6 ; y’(0)=2 . is Y = 2e2x - 4e-3x also a solution of this proble

Explain the difference in elevation between bm and tp2, Based on the inform...

Based on the information provided in Figure, the difference in elevation between BM and TP 2 is most nearly: Solution: Set up a Table as shown below and insert the kno

Calculate concrete yield in cubic feet per sack of cement, Calculate the Co...

Calculate the Concrete Yield in Cubic Feet per Sack of Cement A concrete mix design is 1: 1.9: 2.8 by weight.  The water cement ratio is 7 gallons of water per sack.  The aggre

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd