Stone slab culverts with abutments, Mechanical Engineering

Assignment Help:

Stone Slab Culverts with Abutments and Piers:

Where good quality stone slabs are available like granite slabs, they can be used for superstructure of culverts, with suitable masonry abutments. Spans of such slabs are necessarily small, say upto one metre. Such culverts can be constructed for rural roads (Other District Roads and Village Roads).

RCC Slab Culverts

RCC slab culverts with masonry abutments and piers can be constructed for individual spans upto 6 m.

RCC Box Culverts

RCC Box culverts are ideal for in-situ constructions for opening of size upto 5 m. They can be constructed in square boxes or rectangular boxes, depending upon site conditions. Single or multiple boxes can be constructed. The advantage lies in the elimination of the stout abutment sections which are unavoidable in slab construction.


Related Discussions:- Stone slab culverts with abutments

Woodwork, with the aid of notes and sketches describe how you would transfe...

with the aid of notes and sketches describe how you would transfer the design from a sheet of paper onto the wooden panel prior to carving

Illustrate the future trends in automobile, Short answer Type. a) Writ...

Short answer Type. a) Write the difference Between Dry clutch and Wet ? b) What is difference Between Chasis and Frame? c) Illustrate the Future trends in Automobile

Illustrate the process of insulation on pipe, Q. Illustrate the process of ...

Q. Illustrate the process of insulation on pipe? Factory fabricated sectional pipe insulation shall be applied in staggered joint construction and secured with wire loops or ba

Determine initial tension in the belt, A flat belt, 8 mm thick and 100 mm w...

A flat belt, 8 mm thick and 100 mm wide transmits power between two pulleys, running at 1600 m/min. The mass of the belt is 0.9 kg/m length. The angle of lap in the smaller pulle

Design loads and load combinations, Q. Design Loads and Load Combinations? ...

Q. Design Loads and Load Combinations? The Designer shall determine the following loads and specify them on the Data Sheet. Design loads are defined and classified as follows:

Illustrate about the term bearing capacity, Illustrate about the term beari...

Illustrate about the term bearing capacity? The bearing capacity of a soil mass frequently termed as the ability of the soil to carry the loads without any failure. The foun

Driveshaft seals, DRIVESHAFT SEALS Packed gland Sealed by several lay...

DRIVESHAFT SEALS Packed gland Sealed by several layers of asbestos or cotton yarn     Sometimes used two boxes with intervening space separated by steam Problems:     T

Objectives of planning, What are the objectives of Planning, production and...

What are the objectives of Planning, production and control ? What are the decisions involved in PPC ? What are the information needed for these decisions ?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd