State the methods to keep the attackers at bay, Computer Networking

Assignment Help:

State the methods to keep the attackers at bay

Another best methods to keep the attackers at bay is known as network address translator or NAT. The philosophy behind the design of NAT is that the more an attacker knows about the Intranet, the easier it would be attack and cause damage to it. It is sufficient to know the IP addresses of a server to open it and destroy every important data posted on it.

 


Related Discussions:- State the methods to keep the attackers at bay

Wifi and 3g, what is similarity of wifi and 3g

what is similarity of wifi and 3g

What is the networking control unit, The Network Control Unit (NCU) is a fi...

The Network Control Unit (NCU) is a field panel housing electronic modules, terminal blocks, and signal conditioners (pneumatic, linevoltageand electronic) all inside a one enclosu

What are the responsibilities of application layer, What are the responsibi...

What are the responsibilities of Application Layer? The Application Layer enables the user, whether human or software, to access the network. It gives user interfaces and suppo

Time out - transport layer, Time  out Timers  are used to protect  aga...

Time  out Timers  are used to protect  against  lost packet. Each  packet  must have its own logical  timers since  only  a single  packet  will be retransmitted  after timeou

Subnet layer of the tcp-ip model, Q. Subnet layer of the TCP-IP model? ...

Q. Subnet layer of the TCP-IP model? These two layers of the OSI correspond straight to the subnet layer of the TCP/IP model. Majority of the time the lower layers under the

Will the client send a tcp or udp packet, Question: (a) Explain the usa...

Question: (a) Explain the usage of the following parts of the IPv4 datagram format. i. VERS ii. HLEN iii. TOTAL LENGTH iv. SERVICE TYPE v. HEADER CHECKSUM (b) Na

What is uniform delivery time, What is uniform delivery time A uniform ...

What is uniform delivery time A uniform delivery time is required for voice, so amount of jitter in net- work is significant. This could be expressed as standard deviation of d

Signal to noise ratio, Problem 1. Explain the TCP/IP Reference Model wi...

Problem 1. Explain the TCP/IP Reference Model with diagram 2. Describe the following Maximum Data Rate of a Channel Signal to Noise Ratio   3. Describe the

Common syntax of openmp, Q. Common syntax of OpenMP? Every OpenMP direc...

Q. Common syntax of OpenMP? Every OpenMP directive begins with #pragma omp. The common syntax is   #pragma omp directive-name [Set of clauses]  where omp is an OpenMP key

Measurement on latency and bandwidth , Measure the performance (both latenc...

Measure the performance (both latency and throughput) of  TCP and UDP protocol stack  running on a pair of PCs  or Workstations in the Lab, and compare the results of your software

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd