Staircase, Civil Engineering

Assignment Help:
The Figure 1 below shows a section through a stairway for a garage in a new proposed dwelling. The stairway is 3 meters wide with 300 mm wide treads(7 treads) and 170 mm high risers(8 risers)The landing(1 landing) and the staircase waist thicknesses are 170 mm. A finishes of 20 mm thick screed will be provided. The characteristic strengths of the materials used are: = 20 MPa = 450 MPa for reinforcement. Use a 20 mm nominal cover to reinforcement and Y12 bars. 3.1 Use the relevant codes of practices to design suitable reinforcement for the stairway to resist the applied loads. 3.2 Design the shear links. 3.3 Check the deflection 3.4 Design the transverse reinforcement

Related Discussions:- Staircase

Hazard, • A potential source of harm - Mechanical hazard - Electrical...

• A potential source of harm - Mechanical hazard - Electrical hazard - Cutting hazard - Toxic hazard - Fire hazard - Explosion hazard

Surveying, if bearing of AB is 190& that of CB is 260,the included angle AB...

if bearing of AB is 190& that of CB is 260,the included angle ABC is how?

Semi elliptical arch, how can i build a semi-elliptical arch out of bricks?...

how can i build a semi-elliptical arch out of bricks?

Loss of prestress due to creep in concrete, Loss of Prestress due to Creep ...

Loss of Prestress due to Creep in Concrete Due to the phenomenon of creep, compressive prestress induced strains in concrete increase. Because of  it, strains of  tendons decre

Explain the unconfined aquifer - ground water, Explain the Unconfined Aquif...

Explain the Unconfined Aquifer Also termed "free aquifer". Groundwater flows by gravity from high head to low head. The upper water surface is termed "water table", is influenc

How to design marginal embankments, Q. How to design Marginal Embankments? ...

Q. How to design Marginal Embankments? Design aspects of marginal embankments are similar to those of approach banks. The aspects needing special attention are dealt with below

Pre-tensioned concrete elements, Pre-tensioned concrete elements It is ...

Pre-tensioned concrete elements It is the act of transferring the stress in prestressing tendons to the concrete member. In the case of pre-tensioned concrete elements, this st

Measure the cohesion of internal friction of the soil, A cylindrical specim...

A cylindrical specimen of a saturated soil fails under an axial stress 150 kN/m 2 in an unconfined compression test. The failure plane makes an angle of 52° with the horizontal.

Surveying, what are tie lines? explain in detail

what are tie lines? explain in detail

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd