Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
What is Spot welding equipment?
Spot welding machines may by classified as follows on the basis of mechanical
Construction;
1. Rocker-arm Machines
2. Press-type machines,
3. Portable machines or Guns, and
4. Multiple-electrodes machines.
A standard spot welding machine possesses the following:
Basic Elements;
1. The frame, which is the main body the machine and houses the transformer and tap switch.
2. A nipper arm which is movable and a fixed lower arm.
3. Welding electrodes.
4. The electrical circuit consisting of a step down transformer which reduces the voltage and proportionally increases the current.
5. The different controls that adjust the magnitudes of current, length of welding time, the contact period and the flow of cooling water.
Clutch spring height: Check clutch spring height with a Vernier caliper. Spring height should be of minimum height of 25.55 mm.
According to the explanation, why reverse will happen in the case of cantilevers? ( that is, tensile stresses will be induced in upper layers and compressive stresses will be induc
Applied load shall elongate the spring: Design a close coiled helical spring which shall deflect 100 mm under a load of 600 N. The radius of the coil is 6 times the wire diame
Normal 0 false false false EN-IN X-NONE X-NONE MicrosoftInternetExplorer4
If High Resistance or Low Current in Primary Coil Circuit Causes of Problem Remedy Disconnected or loose wires
The wall shown is 1 m thick. The left surface of the wall (x=0) is maintained at a constant temperature 200 degrees Celsius. The right surface (x=L=1 m) is insulated. The thermal c
Pneumatic system is a system that uses air to power something. For example, have you seen the tube systems at bank drive-up tellers? Air is used to drive the tubes back and forth f
(a) Describe a vector and scalar ? (b) What is meant by line of action of vector ? (c) What are displacement vectors and position vector ? (d) Calculate the component of t
Illustrate the specification of PDDI (i) The 3-D geometry of the product which is defined by a set of curves, surfaces and volumes. (ii) The topology which describes the se
what is the different torque rating of a helical gear one direction verses the other
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd