Sewage treatment, Mechanical Engineering

Assignment Help:

Q. Sewage Treatment?

Unless located in a metropolitan area, it is common for plants to have sewage treatment facilities for disposal of sewage and grey water generated in the plant. Depending on the size of the plant, treatment facilities may vary from a single septic tank to a combination of settling tanks, pumps, rotating biological contactors and clarifying tanks.


Related Discussions:- Sewage treatment

Discover the maximum thickness required, Discover the maximum thickness req...

Discover the maximum thickness required: A thin cylindrical vessel of 2 m diameter and 4 m length having a particular gas at a pressure of 1.65 N/mm 2 . If the allowable tensi

Solution problems, hello I do not currently have my money. it turns out tha...

hello I do not currently have my money. it turns out that you will not extend your hand to me.

What is hybrid sweep, Hybrid Sweep It combines linear and/or non-linear...

Hybrid Sweep It combines linear and/or non-linear sweep via set operations. In this case, two point sets are swept in two different directions and the two resulting swept volum

Illustration of cam, Illustration of CAM A cam rotating at consisted an...

Illustration of CAM A cam rotating at consisted angular velocity operates an oscillating follower. Draw cam profile for the given data: Angular displacement of the follower

Layout of vessels in plant design, Q. Layout of vessels in plant design? ...

Q. Layout of vessels in plant design? Layout of vessels needs to allow sufficient spacing for instruments, piping, operations, maintenance and firefighting access. Vessels o

What are the safety checks in under batteries and gear, What are the Safety...

What are the Safety consideration in under batteries and gear ? Ans: Alternator:- 1. Suspension pin with cotter pin and anti- rotation plate 2. Alternator safety cha

Product life-cycle management, Product life-cycle management: There ha...

Product life-cycle management: There have also been changes in the use of some pre-existing data formats. Open associations have been formed to encourage some formats to becom

Ratio of belt tension, Prove that the ratio of belt tension is given by the...

Prove that the ratio of belt tension is given by the T 1 / T 2   = e μθ Let  T1 = Tension in belt on the tight side T2 = Tension in belt on the slack side θ = Angle

State of cad data exchange, State of CAD Data Exchange: "Are we closel...

State of CAD Data Exchange: "Are we closely there yet?" the dreaded question we hear wailing from the back of the car. "Yes, nearly there" is our cheerful response. We didn't

Prove the parallelogram law of forces - mechanics, Prove the parallelogram ...

Prove the parallelogram law of forces: Assume that the two forces P and Q act at a point ' O ' as shown in figure given below. The force P can be represented in magnitud

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd