Routing protocol used in design a banking network, Computer Networking

Assignment Help:

You have been asked to design a Banking Network with two primary types of locations.

Branches that will have 3 subnets, one /25 subnet one /26 subnet for ABMS and one /26 subnet for the security system. All subnets can be summarized to one /24 network.
Campus location with multiple /24 subnets in each location, locations vary in size from 60 users to 3000 users in large campuses.
There are 1120 branch locations and 75 Campus locations.

What routing protocol(s) would you recommend for this network? Explain the reasons for your selection; refer to the specific features of the protocols that influenced your selection.

Related Discussions:- Routing protocol used in design a banking network

Define the concept of bgp confederations, Can you define the concept of BGP...

Can you define the concept of BGP confederations?

Name the connecting devices of bridges, Connecting Devices of bridges -...

Connecting Devices of bridges - Five kinds: - Repeaters - Hubs - Bridges - Two- and three-layer switches - Repeaters and hubs - layer one of Internet model -

Off the shelf company, Draw a work breakdown structure (WBS) diagram for th...

Draw a work breakdown structure (WBS) diagram for the project, to show all the planned tasks. This WBS should contain at least two levels. b) Explain the main differences between

What is the igp (interior gateway protocol), Any protocol used by an intern...

Any protocol used by an internetwork to exchange routing data within an autonomous system. E.g. RIP, IGRP and OSPF.

Describe the omni-directional and the directional antennas, Question: a...

Question: a) Describe the following two approaches used towards wireless frequency regulation. i. Regulated Band ii. Unlicensed Band b) An antenna is an electrical c

Osi modle, detail discusion

detail discusion

Point-to-point message passing, In point-to-point message passing, single p...

In point-to-point message passing, single process sends/receives message to/from another process. There are four communication modes for sending a message: i) Buffered mode

operational amplifier and peak detector circuit, Question The operatio...

Question The operational amplifier in the peak detector circuit shown in the figure below is powered from plus and minus 15 V. If Vout is at 1V and Vin is at 0.5V, at approxima

Optimizing stp, Optimizing STP Because there is a separate instance of ...

Optimizing STP Because there is a separate instance of the spanning tree for every active VLAN, a separate root election is conducted for each instance. If the default switch p

Configure static routes on a router, How do you configure static routes on ...

How do you configure static routes on a router?

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages