Plc - programmable logical controller , Electrical Engineering

Assignment Help:

PLC ( Programmable Logical  Controller )

PLC  stand for programmable logical  controller.  PLC   is an  industrial computer  used to monitor inputs and depending upon  their  make decisions  based  on its  program  to control  its outputs to  automate a  machine  or a process. In  another way a PLC  may be called a digitally operating electronic  apparatus because it is basically used  a programmable  memory for the internal storage of  instructions by implementing specific  functions  such as  logic  sequencing. Timing  counting and  arithmetic to control  various  types of machines. They are  used in many industries such as oil  refineries manufacturing  lines  conveyor  system etc.


Related Discussions:- Plc - programmable logical controller

Analog, why h parameter used in low frequency transistor amplitfier

why h parameter used in low frequency transistor amplitfier

Three phase steam turbine generator, A 3 phase 400 volt(line to line) wye c...

A 3 phase 400 volt(line to line) wye connected synchronous motor has Xs= 1 ohm per phase and a negligible armature resistance. The field current is so adjusted that the internal(in

Sketch the frequency response, Q. For the circuits shown in Figure, sketch ...

Q. For the circuits shown in Figure, sketch the frequency response (magnitude and phase) of ¯V out / ¯V in .

Tri state devices, Tri State Devices Tri  State  devices have three  st...

Tri State Devices Tri  State  devices have three  states logic 1  logic  0 and high  impedance. A tri state device ( Buffer/ Inverter) has three  lines output  enable as shown

Calculate maximum reactive power the generator can produce, A 3-phase, wye-...

A 3-phase, wye-connected, 11.8 kV, 100 MVA turbo- generator of 0.8 power factor lagging has a synchronous reactance of 2.0 p.u. on rating. The generator is driven by a steam turbin

Dc power supplies, 1.   Design four (4) different 5 volt DC power supplies...

1.   Design four (4) different 5 volt DC power supplies to operate from 230 volts AC. The four power supplies are to have the same full wave rectifier with capacitive filte

MATLAB support for fault analysis in transmission lines, The devices in pow...

The devices in power system shown in Figure 2 have the following ratings: G1 : 100 MVA, 13.8 kV grounded Y, X” = 0.15 pu, X2 = 0.015 pu Xo = 0.05 pu G2 : 50 MVA, 20.0 kV grounded

Find current through resistor using superposition theorem, Find the current...

Find the current through each resistor for the networking below using Superposition Theorem.

Electron, Electron congratulations

Electron congratulations

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd