Moulding materials, Other Engineering

Assignment Help:

 The commonly used moulding materials for mould making can be broadly classified into the following two groups :

            (a) Metals : Including grey cast iron, steel and anodized aluminium

           (b) Non-metals : Including moulding sands, graphites, plaster of paris silicon carbide, ceramic and wax etc.

Moulding Sand : The common sources of collecting foundary sands are rivers, lakes, sea and deserts.


Related Discussions:- Moulding materials

Identify fire hazards - fire risk assessment , Identify fire hazards: ...

Identify fire hazards: In this part, the process appears to be concentrating on issues that can lead to fire but we have to remember to also consider the presence of a fire wi

Cells, what are the advantage of lithium cell

what are the advantage of lithium cell

Calculate the relative load of mobile broadband subscribers, Question: ...

Question: (a) A mobile operator wants to weigh and allocate cost towards mobile broadband subscribers with mobile broadband at 80% of the traffic and 15% of the subscribers. H

Process of fire risk assessment in uk, Process of fire risk assessment: ...

Process of fire risk assessment: In the UK, the process for  the FRA came out of the process for a general risk assessment. In a general risk assessment hazards are identif

Fluid (liquid) ice protection systems, FLUID (LIQUID) ICE PROTECTION SYSTEM...

FLUID (LIQUID) ICE PROTECTION SYSTEMS: Liquid ice protection systems can be used as either anti-ice or de-ice systems.  The system is designed to project a film or fluid over t

Riveting, Riveting  is a fixed fastening procedure in which the end of the ...

Riveting  is a fixed fastening procedure in which the end of the metal pin is pressed over or spread out by hammering operation. Wrought iron and steel are used for the riveting an

Fundamentals of lift and drag , Lift and drag are merely the resolved compo...

Lift and drag are merely the resolved components in specific directions of a resultant aerodynamic force caused by the relative velocity V of the vehicle through the air. If al

Which scheme provides the best spectrum capacity, Question: (a) What a...

Question: (a) What are the criteria that a frequency planner and a network engineer need to consider during cellular planning and design. (b) Assuming that you work as a c

Output characteristics , OUTPUT CHARACTERISTICS: Figure shows a "Common...

OUTPUT CHARACTERISTICS: Figure shows a "Common Emitter" amplifier stage. Common Emitter Amplifier Stage With no base/emitter bias applied, there will be no collector

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd