models and their classifications, Mechanical Engineering

Assignment Help:
explain classifications of models based on dimensionality,time-reference,degree of generality and degree of closure

Related Discussions:- models and their classifications

Low resistance or very high current in primary coil circuit, If Low Resista...

If Low Resistance or Very High Current in Primary Coil Circuit Causes of Problem Remedy Primary ignition coil short circuited

Handling tools and equipment for skid, Q. Handling tools and equipment for ...

Q. Handling tools and equipment for skid? Lifting or pulling and provisions for transportation of skid shall be in accordance with GS-904-0103, other relevant parts of contract

Thermodynamics, The attached figure depicts an indirectly fired gas turbine...

The attached figure depicts an indirectly fired gas turbine engine. In the gas turbine engine, air is compressed to a high pressure and then heat is added. The high pressure, high

Find out longest span which beam would carry m uniform load, Q.  A supporte...

Q.  A supported rectangular beam with the symmetrical section 200mm in depth is having moment of inertia of 2.26 x 10 -5 m 4 about  its neutral axis. Find out longest span over w

Essence of second law - thermodynamics, Essence of Second Law: Sol: ...

Essence of Second Law: Sol: First law deals with conservation and conversion of energy. But it fails to state the conditions under which the energy conversion are possible.

Explain the principal of resistance welding, Can you explain the principal ...

Can you explain the principal of resistance welding? Classify various Resistance welding processes and Illustrate in detail two of them. With the help of neat and clean graph ex

Planning of railway stations - transport engineering, Planning of Railway S...

Planning of Railway Stations and Facilities Provided: The planning of railway stations should cover the following aspects: (a)        The site selected should be easily ac

Quality of welds produced by submerged arc welding, a) You have been assign...

a) You have been assigned to design a robotics spot welding experiment for low carbon steel sheets. You found an experimental power source for spot welding process which is designe

Evaluate indicated power, (a) Following consideration were recorder during ...

(a) Following consideration were recorder during a test on a single cylinder oil engine : Bore = 300 mm; speed =300 r.p.r.; stroke = 450 mm;  net break load = 1.5KN;

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd