Maintenance requirement at storage tanks, Mechanical Engineering

Assignment Help:

Q. Maintenance requirement at storage tanks?

Little maintenance is required at storage tanks; sometimes access is required for equipment used to remove accumulated solids (this should be noted on P&ID). Wherever possible the berm wall height should allow operators to look into the berm without climbing stairs. Access stairs should be provided at two positions preferably at opposite ends of the storage compound. Stairs should be located to allow operators safe escape routes from the compound in an emergency. Vehicle access into the berm is sometimes required.

Typically access to tank roofs should be by spiral staircase, positioned so that the bottom landing leads personnel towards a safe escape route (upwind of tank). If access to the tank roof is by a straight ladder, that ladder should be located upwind of the tank.


Related Discussions:- Maintenance requirement at storage tanks

What is drilling machine, What is drilling machine The machine used for...

What is drilling machine The machine used for drilling is called drilling machine. The drilling operation can also be accomplished in lathe, in which the drill is held in ta

Beam, calculate the vertical reaction at A in Newtons

calculate the vertical reaction at A in Newtons

Nature of shear force and bending moment - load variation, Define the natur...

Define the nature of shear force and bending moment under load variation. Sol.: The nature of SF and BM variation under two-load region is given in the table below

Systematic layout planning, What are the primary benefits of using computer...

What are the primary benefits of using computerized layout procedures vs. Systematic Layout Planning (SLP) procedures done by hand?

Grinding wheels, Grinding Wheels Implicated to be rotated at relativel...

Grinding Wheels Implicated to be rotated at relatively high rotational velocities within grinding machines, grinding wheels contain a surface of rotation about a central axis.

Counterclockwise direction, Figure presents a gearbox that you are going to...

Figure presents a gearbox that you are going to design. The input shaft rotates at n1= 1500 rpm in a counterclockwise direction. The gearbox is needed to be designed sothat the out

Locomotive boiler, What are the advantages and disadvantaged of locomotive ...

What are the advantages and disadvantaged of locomotive boilers

Estimate the horizontal at equilibrium angel, (Rigid body acceleration) A ...

(Rigid body acceleration) A tank of water accelerates down an icy frictionless ramp of angle . What angle ( ) does the water make with the horizontal at equilibrium?

Calculate the compression ratio - maximum pressure of engine, (a) Derive an...

(a) Derive an expression for the otto cycle to determine the Mean Effective Pressure and efficiency. (b)The two engines are to perform on diesel and otto cycle with the followin

Fms, fms computer control system

fms computer control system

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd