Long-term plans for technical loss reduction, Electrical Engineering

Assignment Help:

Long-Term Plans for Technical Loss Reduction

Long-term measures for technical loss reduction include all measures that require to be taken for the improvement of quality and reliability of power supply and reduction of AT&C losses in the area. These involved upgrading, strengthening and improvement of the Sub-Transmission and Distribution system in a circle to meet the future load demand for the further 5 years.

The present traditional reactive and ad-hoc approach to network development should be replaced through an approach based on technical and reliability requirements, economic considerations of costs of energy loss and expansion of system to meet the growth of prospective demand along with least cost.

Long-term plans based on system studies for phased strengthening and improvement of the distribution systems along with related transmission system have to be prepared and executed.


Related Discussions:- Long-term plans for technical loss reduction

Pass band of the resulting bandpass filter, A bandpass filter design can be...

A bandpass filter design can be accomplished through the cascade connection shown in Figure, where the frequencies between the two cutoffs fall in the passband of both filters and

Show binary coded decimal number system, Q. Show Binary Coded Decimal Numbe...

Q. Show Binary Coded Decimal Number System? If we analysis single digit values for hex, the numbers 0 - F, they represent the values 0 - 15 in decimal, and occupy a nibble. Fre

What is the physical length of this cable, Q. It is desired to cut a λ/4 le...

Q. It is desired to cut a λ/4 length of RG58A/U cable (ε r = 2.3) at 150MHz.What is the physical length of this cable?

Energy stored in a switched inductor, The increase in the current is buildi...

The increase in the current is building up the magnetic field surrounding the coil. Energy is stored in that field. Consider the energy supplied by the voltage source during the

Determine what is the minimum required sampling rate, 1. An analog informat...

1. An analog information signal, whose maximum frequency is 6000Hz, is to be transmitted using a PCM system. The quantization error must not exceed the 1 % of the peak-to- peak an

Show the overflow of arithmetic operations, Q. Show the Overflow of arithme...

Q. Show the Overflow of arithmetic operations? A circumstance takes place because the magnitude of the results of arithmetic operations has become too large for the fixed word

What are the different parameters of jfet, Q. What are the different parame...

Q. What are the different parameters of jfet ? A bipolar junction transistor (BJT) is a current controlled device that is output characteristics of the device are controlled by

Dc machince, what ''s part of dcmotor or dc generator

what ''s part of dcmotor or dc generator

Explain isolated i/o scheme, Explain isolated I/O scheme. In I/O mapped...

Explain isolated I/O scheme. In I/O mapped I/O scheme the addresses allocated to memory locations can also be assigned to I/O devices. Because the same address may be assigned

Quartus, I have a project due tomorrow, i have exhuasted all my resources, ...

I have a project due tomorrow, i have exhuasted all my resources, and cannot understand how to do the project, it is VHDL coding in Quartus program, i can send the assignment if yo

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd